Influence of mesh density on calculated extreme stresses in aortic aneurysms

Result code in IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F16%3APU122007" target="_blank" >RIV/00216305:26210/16:PU122007 - isvavai.cz</a>

Result on the web

<a href="http://www.kme.zcu.cz/acm/acm/issue/view/20" target="_blank" >http://www.kme.zcu.cz/acm/acm/issue/view/20</a>

DOI - Digital Object Identifier

—

Result language

angličtina

Original language name

Influence of mesh density on calculated extreme stresses in aortic aneurysms

Original language description

The paper deals with evaluation of the influence of finite element mesh density on the resulting extreme stresses in models of abdominal aortic aneurysms. In most patient-specific computational models published recently, a free mesh of tetrahedrons is used and any information on density of the applied mesh is often missing. In this study a comparison of different mesh densities has been realized with four patient-specific model geometries, all based on a numerical reconstruction of the unloaded geometry of the aneurysm, and with two different Yeoh-type constitutive models. It has been shown that resulting maximum stresses are not mesh independent; due to a better description of the stress gradient in the critical location, the maximum wall stress increases with increasing number of elements throughout the wall thickness, especially in models without residual stresses. This effect is more pronounced when using Vande Geest constitutive model with higher strain stiffening than for Raghavan-Vorp material parameters. Although the mesh density requirements were not so high when the stress gradient was reduced by taking residual stresses into consideration, even in this case low numbers of elements throughout the wall thickness may give mesh dependent results. Although for a rigorous recommendation of the mesh density more analyses are needed, it was shown that the time consuming procedure of taking residual stresses into consideration cannot be replaced by a simpler model with rough mesh.

Czech name

—

Czech description

—

Type

J_SC - Article in a specialist periodical, which is included in the SCOPUS database

CEP classification

—

OECD FORD branch

10610 - Biophysics

Project

<a href="/en/project/LO1202" target="_blank" >LO1202: NETME CENTRE PLUS</a><br>

Continuities

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Publication year

2016

Confidentiality

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Name of the periodical

Applied andComputational Mechanics

ISSN

1802-680X

e-ISSN

2336-1182

Volume of the periodical

10

Issue of the periodical within the volume

2

Country of publishing house

CZ - CZECH REPUBLIC

Number of pages

14

Pages from-to

97-110

UT code for WoS article

—

EID of the result in the Scopus database

2-s2.0-85010952073