Evaluation of Mechanical Properties and Filler Interaction in the Field of SLA Polymeric Additive Manufacturing

Result code in IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F23%3A43898162" target="_blank" >RIV/44555601:13420/23:43898162 - isvavai.cz</a>

Alternative codes found

RIV/60460709:41310/23:95636

Result on the web

<a href="https://www.mdpi.com/1996-1944/16/14/4955" target="_blank" >https://www.mdpi.com/1996-1944/16/14/4955</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.3390/ma16144955" target="_blank" >10.3390/ma16144955</a>

Result language

angličtina

Original language name

Evaluation of Mechanical Properties and Filler Interaction in the Field of SLA Polymeric Additive Manufacturing

Original language description

The paper deals with research focused on the use of fillers in the field of polymeric materials produced by additive technology SLA (stereolithography). The aim of the research is to evaluate 3D printing parameters, the mechanical properties (tensile strength, hardness), and the interaction of individual phases (polymer matrix and filler) in composite materials using SEM analysis. The tested fillers were cotton flakes and ground carbon fibres in different proportions. For the photosensitive resins, the use of cotton flakes as filler was found to have a positive effect on the mechanical properties not only under static but also under cyclic loading, which is a common cause of material failure in practice. The cyclic stress reference value was set at an amplitude of 5-50% of the maximum force required to break the pure resin in a static tensile test. A positive effect of fillers on the cyclic stress life of materials was demonstrated. The service life of pure resin was only 168 &amp; PLUSMN, 29 cycles. The service life of materials with fillers increased to approximately 400 to 540 cycles for carbon fibre-based fillers and nearly 1000 cycles for cotton flake-based fillers, respectively. In this paper, new composite materials suitable for the use of SLA additive manufacturing techniques are presented. Research demonstrated the possibilities of adding cotton-based fillers in low-cost, commercially available resins. Furthermore, the importance of material research under cyclic loading was demonstrated.

Czech name

—

Czech description

—

Type

J_imp - Article in a specialist periodical, which is included in the Web of Science database

CEP classification

—

OECD FORD branch

20505 - Composites (including laminates, reinforced plastics, cermets, combined natural and synthetic fibre fabrics; filled composites)

Project

—

Continuities

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Publication year

2023

Confidentiality

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Name of the periodical

Materials

ISSN

1996-1944

e-ISSN

1996-1944

Volume of the periodical

16

Issue of the periodical within the volume

14

Country of publishing house

CH - SWITZERLAND

Number of pages

21

Pages from-to

1-21

UT code for WoS article

001036503000001

EID of the result in the Scopus database

2-s2.0-85166248995