Cutting Tool Wear Determination by Measuring Tool Shank Deformation

Result code in IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F11%3A%230002621" target="_blank" >RIV/46747885:24210/11:#0002621 - isvavai.cz</a>

Result on the web

—

DOI - Digital Object Identifier

—

Result language

angličtina

Original language name

Cutting Tool Wear Determination by Measuring Tool Shank Deformation

Original language description

This article shows on possibility to use direct measurement of the tool shank deformation for determination the state of the cutting edge. It is well known that cutting forces are changing with the tool wear. But the changes are not linear and it is verydifficult to use a selected force for effective monitoring. Therefoe the ratio of forces could be possibel to give necessary information. For the forces measurement it is necessary to use dynamometer and this one is undesirable for use in shop floor. Therefore it was used for solution the ratio of deformation created by cutting forces on the body of the tool shank. Deformations of the turning tool were measured on the all four surfaces of the shank body in close propinquity og the cutting tool nose. Outcomes of the research shown in the presented contribution give optimistic result.

Czech name

—

Czech description

—

Type

J_x - Unclassified - Peer-reviewed scientific article (Jimp, Jsc and Jost)

CEP classification

JR - Other machinery industry

OECD FORD branch

—

Project

—

Continuities

Z - Vyzkumny zamer (s odkazem do CEZ)

Publication year

2011

Confidentiality

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Name of the periodical

Strojírenská technologie

ISSN

1211-4162

e-ISSN

—

Volume of the periodical

16

Issue of the periodical within the volume

6

Country of publishing house

CZ - CZECH REPUBLIC

Number of pages

6

Pages from-to

59-64

UT code for WoS article

—

EID of the result in the Scopus database

—