Study of plughing forces on the flank face of cutting tools

Result code in IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F14%3A00003358" target="_blank" >RIV/46747885:24210/14:00003358 - isvavai.cz</a>
Result on the web
—
DOI - Digital Object Identifier
—

Result language
angličtina
Original language name
Study of plughing forces on the flank face of cutting tools
Original language description
Determination of the ploughing forces is necessary for monitoring the wear of the cutting tool in micro-cutting. The aim of this research was to increase the accuracy of determining the ploughing force, the determination of the uncut chip thickness influence on the ploughing force, study of reasons for increased active force using coolant with uncut chip thickness. A new method for determining the ploughing forces is suggested in this book. It was found that the ploughing forces determined by the new method were greater than those determined by the method comparing total forces at different flank levels of wear. It was first established that the uncut chip thickness influences the ploughing force. This publication has been prepared within the project "TECHNOMAT" (reg. No. CZ.1.07/2.2.00/28.0316) which was financed by the European Social Fund and the Czech Republic budget.
Czech name
—
Czech description
—

Publication year
2014
Confidentiality
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Similar results(10)