MECHANICAL PROPERTIES OF HAND-MAKING POLYESTER COMPOSITES
The result's identifiers
Result code in IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F18%3A10239606" target="_blank" >RIV/61989100:27230/18:10239606 - isvavai.cz</a>
Result on the web
<a href="http://www.astrj.com/MECHANICAL-PROPERTIES-OF-HAND-MAKING-POLYESTER-COMPOSITES,91891,0,2.html" target="_blank" >http://www.astrj.com/MECHANICAL-PROPERTIES-OF-HAND-MAKING-POLYESTER-COMPOSITES,91891,0,2.html</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.12913/22998624/91891" target="_blank" >10.12913/22998624/91891</a>
Alternative languages
Result language
angličtina
Original language name
MECHANICAL PROPERTIES OF HAND-MAKING POLYESTER COMPOSITES
Original language description
The aim of this paper is to determine the effect of arrangement of fibreglass fabric plies in a polymer composite on a strength. Based on the experimental results, the real effect of plies arrangement and their most favourable configuration with respect to strength is determined. The experiments were performed on 4 types of handmade composites which had different fibre orientations and thicknesses. The first three of the composites had three plies of fabric. The plies arrangement in Composite I was unchanged, in Composite II the central ply had the 45 degrees orientation, while in Composite III the outside ply (tangential to the adhesive layer) was oriented at 45 degrees. In contrast. Composite IV consisted of five plies with unchanged arrangement. Composite plates were first cut into smaller specimens and then after stabilizing, the composite specimens were subjected to strength tests. The highest tensile strength and elongation are obtained for Composite IV, which was the higher the thickness from the tested composite samples, but for this composite the tensile modulus was lowest value. Composite II has the lowest values of strength parameters among the tested composites, which contain three plies and central ply has the 45 degrees orientation.
Czech name
—
Czech description
—
Classification
Type
J<sub>imp</sub> - Article in a specialist periodical, which is included in the Web of Science database
CEP classification
—
OECD FORD branch
20301 - Mechanical engineering
Result continuities
Project
—
Continuities
S - Specificky vyzkum na vysokych skolach
Others
Publication year
2018
Confidentiality
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Data specific for result type
Name of the periodical
Advances in science and technology-research journal
ISSN
2299-8624
e-ISSN
—
Volume of the periodical
12
Issue of the periodical within the volume
2
Country of publishing house
PL - POLAND
Number of pages
9
Pages from-to
112-120
UT code for WoS article
000441469200017
EID of the result in the Scopus database
—