IMPACT OF EDGE PREPARATION ON SURFACE FINISHING PROPERTIES
The result's identifiers
Result code in IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989100%3A27230%2F24%3A10256052" target="_blank" >RIV/61989100:27230/24:10256052 - isvavai.cz</a>
Alternative codes found
RIV/61989100:27360/24:10256052
Result on the web
<a href="https://www.webofscience.com/wos/woscc/full-record/WOS:001350511600001" target="_blank" >https://www.webofscience.com/wos/woscc/full-record/WOS:001350511600001</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.17973/MMSJ.2024_11_2024083" target="_blank" >10.17973/MMSJ.2024_11_2024083</a>
Alternative languages
Result language
angličtina
Original language name
IMPACT OF EDGE PREPARATION ON SURFACE FINISHING PROPERTIES
Original language description
The properties of protective coatings made from organic coatings on metallic substrates strongly depend on the condition of the substrate surface. This refers to the condition of the edges, welds, and the surface in general. Edge treatment is one of the most important operations prior to the actual coating application. The coating's protective properties and its susceptibility to mechanical damage are directly affected by the edge treatment. The article deals with the problem of edge treatment of the base material and the effect of this treatment on the quality of surface finishing. The edges were modified in three ways on the prepared Kosmalt E 300 T samples. Subsequently, some samples were hot-dip galvanized. An organic coating was then applied as the final surface treatment to all samples. The evaluation of the quality of the surface finishing was carried out on the above-mentioned, differently treated edges. The results strongly indicate the importance of the condition of the substrate surface and its influence on the quality of the final surface finish.
Czech name
—
Czech description
—
Classification
Type
J<sub>imp</sub> - Article in a specialist periodical, which is included in the Web of Science database
CEP classification
—
OECD FORD branch
20301 - Mechanical engineering
Result continuities
Project
—
Continuities
S - Specificky vyzkum na vysokych skolach
Others
Publication year
2024
Confidentiality
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Data specific for result type
Name of the periodical
MM Science Journal
ISSN
1803-1269
e-ISSN
1805-0476
Volume of the periodical
SI
Issue of the periodical within the volume
2024
Country of publishing house
CZ - CZECH REPUBLIC
Number of pages
5
Pages from-to
7591-7596
UT code for WoS article
001350511600001
EID of the result in the Scopus database
—