Laser drilling of alumina ceramics using solid state Nd: YAG laser and QCW fiber laser: Effect of process parameters on the hole geometry

Result code in IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F61989592%3A15310%2F17%3A73583642" target="_blank" >RIV/61989592:15310/17:73583642 - isvavai.cz</a>

Result on the web

<a href="http://apem-journal.org/Archives/2017/APEM12-4_412-420.pdf" target="_blank" >http://apem-journal.org/Archives/2017/APEM12-4_412-420.pdf</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.14743/apem2017.4.268" target="_blank" >10.14743/apem2017.4.268</a>

Result language

angličtina

Original language name

Laser drilling of alumina ceramics using solid state Nd: YAG laser and QCW fiber laser: Effect of process parameters on the hole geometry

Original language description

Nowadays a lot of lasers working at different parameters could be used for machining of a wide spectrum of materials. One of these materials is alumina ceramic as it is hard to machine using conventional methods due to high hardness and brittleness. In this paper the percussion drilling of alumina ceramics was performed by Nd:YAG laser and quasi-continuous-wave fiber laser. Effects of laser wavelength, pulse energy, pulse length and number of pulses were examined and the comparison of produced holes geometry was reported. The results show that it is possible to control the holes dimensions by changing lasers and parameters. Fiber laser provides generation of narrower holes due to its small spot and better beam quality together with high power densities. Shorter pulses 0.5 ms, high peak power 1 kW and energy density around 10 kJ/cm(2) are satisfactory for drilling, as they assured good holes circularity and less amount of melt. For Nd: YAG laser it was found that both entrance and exit holes diameters go up proportionally with the pulse length and pulse energy. The optimum parameters for this laser were pulse length 1 ms as good circularity and less amount of dross was obtained, and energy densities around 1 kJ/cm(2) leading to formation of hole with better quality. Moreover, higher number of pulses improves holes circularity.

Czech name

—

Czech description

—

Type

J_imp - Article in a specialist periodical, which is included in the Web of Science database

CEP classification

—

OECD FORD branch

20504 - Ceramics

Project

Result was created during the realization of more than one project. More information in the Projects tab.

Continuities

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)<br>S - Specificky vyzkum na vysokych skolach

Publication year

2017

Confidentiality

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Name of the periodical

Advances in Production Engineering and Management

ISSN

1854-6250

e-ISSN

—

Volume of the periodical

12

Issue of the periodical within the volume

4

Country of publishing house

SI - SLOVENIA

Number of pages

9

Pages from-to

412-420

UT code for WoS article

000418307100009

EID of the result in the Scopus database

2-s2.0-85038636656