Filters
STRENGTHENING OF REINFORCED CONCRETE MEMBERS USING NSM COMPOSITES REINFORCEMENT
Contribution is thematically focused in the area of strengthening of reinforced concrete structures, and it is closer focused in the strengthening using NSM (near surface mounted reinforcement - reinforcement
JN - Stavebnictví
- 2013 •
- D
Rok uplatnění
D - Stať ve sborníku
Advanced methods of strengthening RC members – Near surface mounted FRP reinforcement mounted FRP reinforcement
Near surface mounted reinforcement (NSM reinforcement) brings an additional to properties of used FRP reinforcement and its position in the strengthened cross-section FRP reinforcement based on ca...
JN - Stavebnictví
- 2013 •
- D
Rok uplatnění
D - Stať ve sborníku
The use of fiber-reinforced concrete in blast and impact design
The paper describes the possibilities of use of fiber reinforced concrete in blast-resistant structures. The propagation of the blast wave is studied, three elementary cases of blast loading are distinguished, remote blast, blast near
JM - Inženýrské stavitelství
- 2010 •
- Jx
Rok uplatnění
Jx - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)
New trends in strengthening of structures using FRP materials
New trends in strengthening concrete, masonry, steel and timber structures are presented. They are especially composite structures with near surface mounted reinforcement (NSMR). Advantages and method of reinforcing
JN - Stavebnictví
- 2005 •
- D
Rok uplatnění
D - Stať ve sborníku
Strengthening of reinforced concrete elements using composite NSM reinforcement
Reinforcement placed in the grooves near the surface (NSM reinforcement) brings to the position of reinforcement occurs to maximize the effective height of the element, which in turn may exaggerate the use...
JN - Stavebnictví
- 2012 •
- D
Rok uplatnění
D - Stať ve sborníku
Strengthening of reinforced concrete elements using NSMR technique
of externally bonded reinforcement (composite lamellas), strengthening additional steel reinforcement and other ways. The following article will deal with a relatively of new method of strengthening using the additional composite <...
JN - Stavebnictví
- 2012 •
- D
Rok uplatnění
D - Stať ve sborníku
Tests of UHPC Thin Plates Reinforced by 2D Textile Glass Reinforcement and PVA Fibres
PVA fibers 20 mm long and 2D textile glass reinforcement with 20 x 20 mm net. This reinforcement was located near the lower surface of the board. Instead of a traditional reinforcement the 2D textile glas...
JM - Inženýrské stavitelství
- 2014 •
- D
Rok uplatnění
D - Stať ve sborníku
Experimental Tests of White UHPC Plates Reinforced PVA Fibres and Textile Glass Reinforcement
. The reinforcement was placed and fixed near the lower surface of the slabs. The course white UHPC. These slabs are reinforced by scattered PVA fibres and textile glass reinforcement in form of 2D net. Th...
JM - Inženýrské stavitelství
- 2015 •
- D
Rok uplatnění
D - Stať ve sborníku
Tests of UHPC Thin Plates Reinforced by 2D Textile Glass Reinforcement and PVA Fibres
. This reinforcement was located near the lower surface of the board. Instead of a tradi-tional reinforcement the 2D textile glass reinforcement that is equipped with the protectionThe paper is focused on ...
JM - Inženýrské stavitelství
- 2014 •
- D
Rok uplatnění
D - Stať ve sborníku
Influence of reinforcement in ISO girder on heat flow and internal surface temperature
The paper is focused on the using of stell reinforcement and the effect of reinforcement on the heat flow and surface temperatures. Some examples which will tell you knowledge about thermal flow throw armature....
JN - Stavebnictví
- 2011 •
- O
Rok uplatnění
O - Ostatní výsledky
- 1 - 10 out of 97 797