Effect of the rivet hole tolerance on the stress severity factor

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00010669%3A_____%2F21%3AN0000065" target="_blank" >RIV/00010669:_____/21:N0000065 - isvavai.cz</a>

Výsledek na webu

<a href="https://mater-tehnol.si/index.php/MatTech/article/view/124" target="_blank" >https://mater-tehnol.si/index.php/MatTech/article/view/124</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17222/mit.2020.146" target="_blank" >10.17222/mit.2020.146</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of the rivet hole tolerance on the stress severity factor

Popis výsledku v původním jazyce

This work is focused on a quantitative procedure for estimating the generally unfavourable effects of incorrect drilled holes, which are characterized by the oversize initial clearance between a rivet and a hole, have on the fatigue life of riveted joints. The solution is based on an analytical approach using the stress severity factor concept.An experimental programme with riveted joint specimens characterized by low load transfer factors was realized in the Czech aerospace research centre (VZLU) test lab under constant amplitude loading. The holes for rivet joints with 4-mm diameters were prepared with a clearance in the range from 0.0 mm to 0.16 mm. The force-controlled riveting was applied using a constant pressure force.

Název v anglickém jazyce

Effect of the rivet hole tolerance on the stress severity factor

Popis výsledku anglicky

This work is focused on a quantitative procedure for estimating the generally unfavourable effects of incorrect drilled holes, which are characterized by the oversize initial clearance between a rivet and a hole, have on the fatigue life of riveted joints. The solution is based on an analytical approach using the stress severity factor concept.An experimental programme with riveted joint specimens characterized by low load transfer factors was realized in the Czech aerospace research centre (VZLU) test lab under constant amplitude loading. The holes for rivet joints with 4-mm diameters were prepared with a clearance in the range from 0.0 mm to 0.16 mm. The force-controlled riveting was applied using a constant pressure force.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2021

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Materiali in Tehnologije

ISSN

1580-2949

e-ISSN

1580-3414

Svazek periodika

55

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

SI - Slovinská republika

Počet stran výsledku

6

Strana od-do

237-242

Kód UT WoS článku

000737311900010

EID výsledku v databázi Scopus

—