Patch Antenna Array for X-band FMCW Senzor

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216275%3A25530%2F15%3A39900159" target="_blank" >RIV/00216275:25530/15:39900159 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.1109/COMITE.2015.7120340" target="_blank" >http://dx.doi.org/10.1109/COMITE.2015.7120340</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1109/COMITE.2015.7120340" target="_blank" >10.1109/COMITE.2015.7120340</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Patch Antenna Array for X-band FMCW Senzor

Popis výsledku v původním jazyce

The paper describes concept of the patch antenna array for X-band FMCW (Frequency Modulated Continuous Wave) radar. This antenna is part of a system for detection of obstacles in the near vicinity of a helicopter. The intended function of this system isto detect and inform the flight crew of obstacles while maneuvering at low airspeed typically close to the ground. The antenna works at center frequency 9.5 GHz with bandwidth of 450 MHz. The antenna is fabricated by microstrip technology. Since the broadband antenna is need, the antenna consists of two dielectric layers. The first layer consists of radiation elements (patches). The second layer has, on its top side, a ground plane and on the bottom side, a signal distribution network for a series-fed patch antenna array. Between these two layers is a gap which allows a required bandwidth to be achieved.

Název v anglickém jazyce

Patch Antenna Array for X-band FMCW Senzor

Popis výsledku anglicky

The paper describes concept of the patch antenna array for X-band FMCW (Frequency Modulated Continuous Wave) radar. This antenna is part of a system for detection of obstacles in the near vicinity of a helicopter. The intended function of this system isto detect and inform the flight crew of obstacles while maneuvering at low airspeed typically close to the ground. The antenna works at center frequency 9.5 GHz with bandwidth of 450 MHz. The antenna is fabricated by microstrip technology. Since the broadband antenna is need, the antenna consists of two dielectric layers. The first layer consists of radiation elements (patches). The second layer has, on its top side, a ground plane and on the bottom side, a signal distribution network for a series-fed patch antenna array. Between these two layers is a gap which allows a required bandwidth to be achieved.

Druh

D - Stať ve sborníku

CEP obor

JW - Navigace, spojení, detekce a protiopatření

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Proceedings of 14th Conference on Microwave Techniques, COMITE 2015

ISBN

9781479981212

ISSN

—

e-ISSN

—

Počet stran výsledku

5

Strana od-do

81-85

Název nakladatele

IEEE (Institute of Electrical and Electronics Engineers)

Místo vydání

New York

Místo konání akce

Pardubice

Datum konání akce

22. 4. 2015

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—