Modified Cement-based Mortars: Crack Initiation and Volume Changes

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26110%2F15%3APU114747" target="_blank" >RIV/00216305:26110/15:PU114747 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Modified Cement-based Mortars: Crack Initiation and Volume Changes

Popis výsledku v původním jazyce

The aim of this paper was to quantify the crack initiation and volume changes of three types of fine-grain cement-based composites: the reference one including Portland cement only and the other two with the mass fraction 20 % of Portland cement replaced by granulated blast-furnace slag or pulverized-coal fly ash. Half of the specimens from each mixture were cured according to ASTM C1260-94 and ASTM C1567-07, other specimens were cured in water. The length changes were measured during the curing (a test for the risk of the alkali-silica reactivity). Furthermore, a three-point-bending test was performed on these specimens to obtain the fracture parameters, which were determined using a double-K fracture model. It was found that the type of specimen curing has a significant effect on the volume changes and a moderate influence on the elasticity modulus, the crack initiation and fracture-toughness values.

Název v anglickém jazyce

Modified Cement-based Mortars: Crack Initiation and Volume Changes

Popis výsledku anglicky

The aim of this paper was to quantify the crack initiation and volume changes of three types of fine-grain cement-based composites: the reference one including Portland cement only and the other two with the mass fraction 20 % of Portland cement replaced by granulated blast-furnace slag or pulverized-coal fly ash. Half of the specimens from each mixture were cured according to ASTM C1260-94 and ASTM C1567-07, other specimens were cured in water. The length changes were measured during the curing (a test for the risk of the alkali-silica reactivity). Furthermore, a three-point-bending test was performed on these specimens to obtain the fracture parameters, which were determined using a double-K fracture model. It was found that the type of specimen curing has a significant effect on the volume changes and a moderate influence on the elasticity modulus, the crack initiation and fracture-toughness values.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20101 - Civil engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Materiali in tehnologije

ISSN

1580-2949

e-ISSN

1580-3414

Svazek periodika

49

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

SI - Slovinská republika

Počet stran výsledku

5

Strana od-do

557-561

Kód UT WoS článku

000358560800014

EID výsledku v databázi Scopus

2-s2.0-84937026743