Effect of Specimen Geometry on Selected Physical and Mechanical Properties of Epoxy-based Building Materials
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26110%2F20%3APU135060" target="_blank" >RIV/00216305:26110/20:PU135060 - isvavai.cz</a>
Výsledek na webu
<a href="https://www.scientific.net/KEM.868.24" target="_blank" >https://www.scientific.net/KEM.868.24</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.4028/www.scientific.net/KEM.868.24" target="_blank" >10.4028/www.scientific.net/KEM.868.24</a>
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Effect of Specimen Geometry on Selected Physical and Mechanical Properties of Epoxy-based Building Materials
Popis výsledku v původním jazyce
The paper deals with problematics of the influence of size and shape of test specimens prepared according to the valid standard procedures in comparison to specimens prepared according to the standards used for different types of materials (grouts, coatings). The aim of this paper is to verify the possibility of using non-standard specimen sizes to reduce the economic demands of the development of building materials. The issue is tested on the polymer composites prepared in three different amounts of the filler. The polymer composite based on epoxy resin serves as a representative and homogenous material which achieves the same results under various curing temperatures and humidity. The porous structure of prepared samples was also studied and its effect on the selected mechanical properties was observed. It was shown that the specimen shape and size had impact on the mechanical properties of epoxy-based composites.
Název v anglickém jazyce
Effect of Specimen Geometry on Selected Physical and Mechanical Properties of Epoxy-based Building Materials
Popis výsledku anglicky
The paper deals with problematics of the influence of size and shape of test specimens prepared according to the valid standard procedures in comparison to specimens prepared according to the standards used for different types of materials (grouts, coatings). The aim of this paper is to verify the possibility of using non-standard specimen sizes to reduce the economic demands of the development of building materials. The issue is tested on the polymer composites prepared in three different amounts of the filler. The polymer composite based on epoxy resin serves as a representative and homogenous material which achieves the same results under various curing temperatures and humidity. The porous structure of prepared samples was also studied and its effect on the selected mechanical properties was observed. It was shown that the specimen shape and size had impact on the mechanical properties of epoxy-based composites.
Klasifikace
Druh
D - Stať ve sborníku
CEP obor
—
OECD FORD obor
20501 - Materials engineering
Návaznosti výsledku
Projekt
—
Návaznosti
S - Specificky vyzkum na vysokych skolach
Ostatní
Rok uplatnění
2020
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název statě ve sborníku
Rehabilitation and Reconstruction of Buildings III
ISBN
9783035736533
ISSN
1013-9826
e-ISSN
—
Počet stran výsledku
8
Strana od-do
24-31
Název nakladatele
Trans Tech Publications Ltd
Místo vydání
Switzerland
Místo konání akce
Prague
Datum konání akce
28. 11. 2019
Typ akce podle státní příslušnosti
WRD - Celosvětová akce
Kód UT WoS článku
—