Vliv modifikace topografie na nekonformní kontakty za podmínek smíšeného mazání

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F08%3APU75456" target="_blank" >RIV/00216305:26210/08:PU75456 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of surface texturing on mixed lubricated non-conformal contacts

Popis výsledku v původním jazyce

The behaviour of surface texturing based on shallow micro-dents was observed within mixed lubricated non-conformal contacts and compared with results obtained under thin film elastohydrodynamic conditions. Thin film colorimetric interferometry was used to observe the changes in lubrication film thickness. It was found that lubricant emitted by micro-dents could effectively lift off the real roughness features that provided an increase in average but also the local minimum film thicknesses. On the contrary to smooth contact conditions no film thickness reduction is obvious either downstream or upstream the micro-dent. The possible beneficial effect of surface texturing on mixed lubricated contact was checked through the qualitative wear test. It confirmed that an array of shallow micro-dents reduced asperity interactions of rubbing surfaces. Moreover, the effect of micro-dents on rolling contact fatigue was also considered in this study. It has been shown that individual dents would hav

Název v anglickém jazyce

Effect of surface texturing on mixed lubricated non-conformal contacts

Popis výsledku anglicky

The behaviour of surface texturing based on shallow micro-dents was observed within mixed lubricated non-conformal contacts and compared with results obtained under thin film elastohydrodynamic conditions. Thin film colorimetric interferometry was used to observe the changes in lubrication film thickness. It was found that lubricant emitted by micro-dents could effectively lift off the real roughness features that provided an increase in average but also the local minimum film thicknesses. On the contrary to smooth contact conditions no film thickness reduction is obvious either downstream or upstream the micro-dent. The possible beneficial effect of surface texturing on mixed lubricated contact was checked through the qualitative wear test. It confirmed that an array of shallow micro-dents reduced asperity interactions of rubbing surfaces. Moreover, the effect of micro-dents on rolling contact fatigue was also considered in this study. It has been shown that individual dents would hav

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

<a href="/cs/project/ME%20905" target="_blank" >ME 905: Vliv cílené modifikace topografie třecích povrchů na účinnost mazacích filmů při snižování tření a opotřebení strojních částí</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2008

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Tribology International

ISSN

0301-679X

e-ISSN

—

Svazek periodika

41

Číslo periodika v rámci svazku

11

Stát vydavatele periodika

NL - Nizozemsko

Počet stran výsledku

11

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—