Investigation on capability of the reaming process using minimal quantity lubrication

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F09%3APU83178" target="_blank" >RIV/00216305:26210/09:PU83178 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Investigation on capability of the reaming process using minimal quantity lubrication

Popis výsledku v původním jazyce

An investigation on reaming using minimal quantity lubrication (MQL) was carried out with the scope of documenting process capability using a metrological approach. Reaming tests were carried out on austenitic stainless steel, using HSS reamers with different cutting data and lubrication conditions. The reaming operations were compared with respect to a number of evaluation parameters, both hole quality (diameter, roundness, cylindricity and surface roughness) and cutting forces (reaming thrust and torque). Absolute average values as well as experimental standard deviations of the evaluation parameters were calculated, and uncertainty budgeting was performed for all measurands. Results show that reaming operations at lower cutting speed and feed produce low process scatter. The use of smaller depth of cut (i.e. smaller reamer diameter) resulted in larger reaming torque scatter than when a larger depth of cut was employed. The suitability of MQL for reaming was proven under the investig

Název v anglickém jazyce

Investigation on capability of the reaming process using minimal quantity lubrication

Popis výsledku anglicky

An investigation on reaming using minimal quantity lubrication (MQL) was carried out with the scope of documenting process capability using a metrological approach. Reaming tests were carried out on austenitic stainless steel, using HSS reamers with different cutting data and lubrication conditions. The reaming operations were compared with respect to a number of evaluation parameters, both hole quality (diameter, roundness, cylindricity and surface roughness) and cutting forces (reaming thrust and torque). Absolute average values as well as experimental standard deviations of the evaluation parameters were calculated, and uncertainty budgeting was performed for all measurands. Results show that reaming operations at lower cutting speed and feed produce low process scatter. The use of smaller depth of cut (i.e. smaller reamer diameter) resulted in larger reaming torque scatter than when a larger depth of cut was employed. The suitability of MQL for reaming was proven under the investig

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2009

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

CIRP Journal of Manufacturing Science and Technology

ISSN

1755-5817

e-ISSN

—

Svazek periodika

2

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

FR - Francouzská republika

Počet stran výsledku

8

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—