Modelling of ductile fracture for sub-sized three-point-bend geometry

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F12%3APU102951" target="_blank" >RIV/00216305:26210/12:PU102951 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/68081723:_____/12:00385658

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Modelling of ductile fracture for sub-sized three-point-bend geometry

Popis výsledku v původním jazyce

The contribution deals with the simulation of R-curve using complete Gurson model of ductile fracture. The R-curve was experimentally determined for a Eurofer97 steel on sub-sized three-point-bend geometry in previous study. To apply complete Gurson model the parameters describing the voids' behaviour and characteristic length parameter need to be determined. The nucleation parameters were identified by single specimen method of smooth tensile test specimen and from metallographic examination of fracture micro-mechanism. The characteristic length parameter was derived by fitting load versus deflection curves of sub-sized specimens. The simulations of the tests were carried out by FEM software ABAQUS 6.11 in Standard and Explicit modules. The identification was supported by parametric studies. Comparing experimental and simulated R-curve the ductile tearing was not successfully achieved. Insufficient calibrated parameters as a result non-uniqueness problem of single specimen method were

Název v anglickém jazyce

Modelling of ductile fracture for sub-sized three-point-bend geometry

Popis výsledku anglicky

The contribution deals with the simulation of R-curve using complete Gurson model of ductile fracture. The R-curve was experimentally determined for a Eurofer97 steel on sub-sized three-point-bend geometry in previous study. To apply complete Gurson model the parameters describing the voids' behaviour and characteristic length parameter need to be determined. The nucleation parameters were identified by single specimen method of smooth tensile test specimen and from metallographic examination of fracture micro-mechanism. The characteristic length parameter was derived by fitting load versus deflection curves of sub-sized specimens. The simulations of the tests were carried out by FEM software ABAQUS 6.11 in Standard and Explicit modules. The identification was supported by parametric studies. Comparing experimental and simulated R-curve the ductile tearing was not successfully achieved. Insufficient calibrated parameters as a result non-uniqueness problem of single specimen method were

Druh

D - Stať ve sborníku

CEP obor

JL - Únava materiálu a lomová mechanika

OECD FORD obor

—

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2012

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Engineering mechanics 2012

ISBN

978-80-86246-40-6

ISSN

—

e-ISSN

—

Počet stran výsledku

6

Strana od-do

1253-1258

Název nakladatele

Institute of Theoretical and Applied Mechanics

Místo vydání

Praha

Místo konání akce

Svratka

Datum konání akce

14. 5. 2012

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—