Influence of processing on microstructure and mechanical properties of magnesium alloy AZ91

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F16%3APU119390" target="_blank" >RIV/00216305:26210/16:PU119390 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of processing on microstructure and mechanical properties of magnesium alloy AZ91

Popis výsledku v původním jazyce

This paper deals with differences of mechanical characteristics and fracture surface morphology of AZ91 magnesium alloy in extruded state and after subsequent equal channel angular pressing (ECAP). According to the results, the tensile properties were not controlled by grain size only as values of the tensile strength and 0.2 proof stress were similar for both alloys despite having average grain size 15.9 μm for the extruded alloy and 1.2 μm for the ECAPed alloy. In contrast, microhardness seemed to be dependent solely on the grain size. Fractographic analysis has shown changes in the damage mode from quasi-cleavage fracture in extruded state to rather ductile fracture with dimple morphology in exECAPed state during tensile loading.

Název v anglickém jazyce

Influence of processing on microstructure and mechanical properties of magnesium alloy AZ91

Popis výsledku anglicky

This paper deals with differences of mechanical characteristics and fracture surface morphology of AZ91 magnesium alloy in extruded state and after subsequent equal channel angular pressing (ECAP). According to the results, the tensile properties were not controlled by grain size only as values of the tensile strength and 0.2 proof stress were similar for both alloys despite having average grain size 15.9 μm for the extruded alloy and 1.2 μm for the ECAPed alloy. In contrast, microhardness seemed to be dependent solely on the grain size. Fractographic analysis has shown changes in the damage mode from quasi-cleavage fracture in extruded state to rather ductile fracture with dimple morphology in exECAPed state during tensile loading.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

<a href="/cs/project/LO1202" target="_blank" >LO1202: NETME CENTRE PLUS</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Materiálové inžinierstvo

ISSN

1335-0803

e-ISSN

—

Svazek periodika

23

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

SK - Slovenská republika

Počet stran výsledku

6

Strana od-do

27-32

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—