Optimization of the Cutting Speed for Ti-6Al-4V Using WEDM Depending on Quality of the Machined Surface

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F16%3APU121227" target="_blank" >RIV/00216305:26210/16:PU121227 - isvavai.cz</a>

Výsledek na webu

<a href="http://ieeexplore.ieee.org/abstract/document/7827860/" target="_blank" >http://ieeexplore.ieee.org/abstract/document/7827860/</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Optimization of the Cutting Speed for Ti-6Al-4V Using WEDM Depending on Quality of the Machined Surface

Popis výsledku v původním jazyce

Wire electrical discharge machining (WEDM) is an unconventional technology of machining that applies physical principles for material removal. To ensure efficient machining, it is appropriate to have the cutting speed as high as possible; however, the quality of the surface to be machined shall also be taken into account. Since the cutting speed cannot be directly set on the machine, but depends on the setting of individual machine parameters, an experiment was designed to find optimum values of individual parameters to maximise the cutting speed. The examined parameters included: gap voltage, pulse on time, pulse off time, wire speed and discharge current. In addition, the study dealt with the evaluation of morphology and quality of the surfaces of machined samples manufactured at the highest and the lowest speed using a contactless profilometer based on the principle of coherence correlation interferometry.

Název v anglickém jazyce

Optimization of the Cutting Speed for Ti-6Al-4V Using WEDM Depending on Quality of the Machined Surface

Popis výsledku anglicky

Wire electrical discharge machining (WEDM) is an unconventional technology of machining that applies physical principles for material removal. To ensure efficient machining, it is appropriate to have the cutting speed as high as possible; however, the quality of the surface to be machined shall also be taken into account. Since the cutting speed cannot be directly set on the machine, but depends on the setting of individual machine parameters, an experiment was designed to find optimum values of individual parameters to maximise the cutting speed. The examined parameters included: gap voltage, pulse on time, pulse off time, wire speed and discharge current. In addition, the study dealt with the evaluation of morphology and quality of the surfaces of machined samples manufactured at the highest and the lowest speed using a contactless profilometer based on the principle of coherence correlation interferometry.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

<a href="/cs/project/LO1202" target="_blank" >LO1202: NETME CENTRE PLUS</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Mechatronika 2016

ISBN

978-80-01-05882-4

ISSN

—

e-ISSN

—

Počet stran výsledku

5

Strana od-do

450-454

Název nakladatele

Czech Technical University in Prague, Faculty of Electrical Engineering

Místo vydání

Praha

Místo konání akce

Praha

Datum konání akce

7. 12. 2016

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

000400174000076