Biaxial test of tubes using elastomer

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F16%3APU122128" target="_blank" >RIV/00216305:26210/16:PU122128 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Biaxial test of tubes using elastomer

Popis výsledku v původním jazyce

To obtain the values of material characteristics of tubes such as the strain hardening exponent n and the strength coefficient K is most frequently used the hydraulic bulge test. The tool and an additional equipment are often complicated and very expensive for this test. This article deals with the question whether it would be possible to obtain the corresponding values n and K by the simple biaxial test of tube using elastomer. To solve this problem, a simple tool was designed and the verification tests were realized for thin-walled tubes from material AISI 321. The results showed that it’s not possible to obtain real values n and K by biaxial test of tubes using elastomer. The reason is the elastic forming medium, which complicates the evaluation of these material characteristics, because the elastomer introduces many additional factors into the forming process.

Název v anglickém jazyce

Biaxial test of tubes using elastomer

Popis výsledku anglicky

To obtain the values of material characteristics of tubes such as the strain hardening exponent n and the strength coefficient K is most frequently used the hydraulic bulge test. The tool and an additional equipment are often complicated and very expensive for this test. This article deals with the question whether it would be possible to obtain the corresponding values n and K by the simple biaxial test of tube using elastomer. To solve this problem, a simple tool was designed and the verification tests were realized for thin-walled tubes from material AISI 321. The results showed that it’s not possible to obtain real values n and K by biaxial test of tubes using elastomer. The reason is the elastic forming medium, which complicates the evaluation of these material characteristics, because the elastomer introduces many additional factors into the forming process.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing TECHNOLOGY

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

7

Strana od-do

765-771

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-84991107734