HEAT TRANSFER COEFFICIENT DURING SPRAY COOLING OF VERY HOT SURFACES BY FLAT NOZZLES

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F21%3APU142719" target="_blank" >RIV/00216305:26210/21:PU142719 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

HEAT TRANSFER COEFFICIENT DURING SPRAY COOLING OF VERY HOT SURFACES BY FLAT NOZZLES

Popis výsledku v původním jazyce

An experimental investigation of spray cooling intensity was carried out to determine the heat transfer coefficient for different spray characteristics on a moving steel surface above the Leidenfrost point. The austenitic steel plate, which had an initial temperature of 1200°C, was cooled by a nozzle moving at a speed of 1 m·min-1 and spraying upwards onto the cooled surface at a distance of 250 mm. To discover the influence of different spray characteristics, flat nozzles were used, which can be sorted into two groups. Each group is comprised of one water nozzle and one mist nozzle tested at two air pressures. The first group operated with a water flow rate of 11 l·min-1 and the second group with a rate of 6 l·min-1 . The nozzles in each group were chosen to give different spray characteristics, while the water flow rate and spray angle are the same for the whole group, therefore the effect of the other parameters of the spray should be revealed and not the water flow rate only. Measurements

Název v anglickém jazyce

HEAT TRANSFER COEFFICIENT DURING SPRAY COOLING OF VERY HOT SURFACES BY FLAT NOZZLES

Popis výsledku anglicky

An experimental investigation of spray cooling intensity was carried out to determine the heat transfer coefficient for different spray characteristics on a moving steel surface above the Leidenfrost point. The austenitic steel plate, which had an initial temperature of 1200°C, was cooled by a nozzle moving at a speed of 1 m·min-1 and spraying upwards onto the cooled surface at a distance of 250 mm. To discover the influence of different spray characteristics, flat nozzles were used, which can be sorted into two groups. Each group is comprised of one water nozzle and one mist nozzle tested at two air pressures. The first group operated with a water flow rate of 11 l·min-1 and the second group with a rate of 6 l·min-1 . The nozzles in each group were chosen to give different spray characteristics, while the water flow rate and spray angle are the same for the whole group, therefore the effect of the other parameters of the spray should be revealed and not the water flow rate only. Measurements

Druh

O - Ostatní výsledky

CEP obor

—

OECD FORD obor

20303 - Thermodynamics

Projekt

<a href="/cs/project/LTAUSA19053" target="_blank" >LTAUSA19053: Principy tvorby a využití vodovzdušné směsi v průmyslových aplikacích</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2021

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů