Machining a flax fibre composite using tools with different geometries

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26210%2F26%3A0201042" target="_blank" >RIV/00216305:26210/26:0201042 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Machining a flax fibre composite using tools with different geometries

Popis výsledku v původním jazyce

This article specifically focuses on the machining of composite materials reinforced with flax fibres, with the aim of identifying the main factors influencing the cutting process and the quality of the machined surface. The results revealed that the tool geometry featured the main factor affecting the vibrations and burr formation when machining of composite materials. Series of experiments unveiled that the tool with the helix angle of 7° and a higher number of cutting edges achieved the best results across most measured parameters such as burr formation. In contrast, the end mill with the helix angle of 45° exhibited the worse results in case of burr formation compared to the helix angle 7°.

Název v anglickém jazyce

Machining a flax fibre composite using tools with different geometries

Popis výsledku anglicky

This article specifically focuses on the machining of composite materials reinforced with flax fibres, with the aim of identifying the main factors influencing the cutting process and the quality of the machined surface. The results revealed that the tool geometry featured the main factor affecting the vibrations and burr formation when machining of composite materials. Series of experiments unveiled that the tool with the helix angle of 7° and a higher number of cutting edges achieved the best results across most measured parameters such as burr formation. In contrast, the end mill with the helix angle of 45° exhibited the worse results in case of burr formation compared to the helix angle 7°.

Druh

O - Ostatní výsledky

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2025

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů