The low-cost design approach to the active magnetic bearing test stand

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26220%2F20%3APU137795" target="_blank" >RIV/00216305:26220/20:PU137795 - isvavai.cz</a>

Výsledek na webu

<a href="https://ieeexplore-ieee-org.ezproxy.lib.vutbr.cz/document/9286710" target="_blank" >https://ieeexplore-ieee-org.ezproxy.lib.vutbr.cz/document/9286710</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1109/ME49197.2020.9286710" target="_blank" >10.1109/ME49197.2020.9286710</a>

Jazyk výsledku

angličtina

Název v původním jazyce

The low-cost design approach to the active magnetic bearing test stand

Popis výsledku v původním jazyce

Active magnetic bearings (AMB) are used in much high-speed application nowadays. Early development usually requires to measure AMB properties outside its application to adjust and optimize control loops and warm-up/lift-down logic. Many laboratories developed their own, more or less complex test-stands. Such as stands are usually expensive and they are not usually applicable for all types of AMB. Magnetic bearings vary in geometry and measuring systems need some adjustments or new parts have to be manufacture to fit the system. There are new technologies that can enhance the stand itself production time and reduce the costs. 3D printed parts and parts widely available in hardware stores support the idea of a low-cost system build. In this paper design requirements for test-stand are discussed alongside the low-cost test stand design proposal employed by AMB.

Název v anglickém jazyce

The low-cost design approach to the active magnetic bearing test stand

Popis výsledku anglicky

Active magnetic bearings (AMB) are used in much high-speed application nowadays. Early development usually requires to measure AMB properties outside its application to adjust and optimize control loops and warm-up/lift-down logic. Many laboratories developed their own, more or less complex test-stands. Such as stands are usually expensive and they are not usually applicable for all types of AMB. Magnetic bearings vary in geometry and measuring systems need some adjustments or new parts have to be manufacture to fit the system. There are new technologies that can enhance the stand itself production time and reduce the costs. 3D printed parts and parts widely available in hardware stores support the idea of a low-cost system build. In this paper design requirements for test-stand are discussed alongside the low-cost test stand design proposal employed by AMB.

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20201 - Electrical and electronic engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2020

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

2020 20th International Conference on Mechatronics - Mechatronika (ME)

ISBN

978-1-7281-5602-6

ISSN

—

e-ISSN

—

Počet stran výsledku

4

Strana od-do

227-231

Název nakladatele

Neuveden

Místo vydání

Neuveden

Místo konání akce

Praha

Datum konání akce

2. 12. 2020

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—