Enhancement of Magnetic Properties of 41CrMo4 Steel by Means of Diffusion Coatings

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F00216305%3A26620%2F16%3APU119778" target="_blank" >RIV/00216305:26620/16:PU119778 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Enhancement of Magnetic Properties of 41CrMo4 Steel by Means of Diffusion Coatings

Popis výsledku v původním jazyce

The knowledge of magnetic and transport properties of construction steels for magnetic circuits plays an important role. Three different techniques: (i) flame spray, (ii) twin wire arc spray and (iii) powder mixture with halide activator were used to produce Si, CuSn6 and Si coatings, respectively, on the 41CrMo4 steel ring substrates. Immediately after the thermal spraying or inserting the steels into the powder mixture was used isothermal heat treatment at the temperatures of 800 °C / 6 hrs, 1000 °C / 4 hrs and 1250 °C / 2 hrs to produce the diffusion coatings. Several coating systems consisting of different phases and thicknesses were manufactured. Opto-digital microscope, scanning electron microscope and digital image analysis, second equipped with energy dispersive microanalyzer, were utilized to characterize the microstructure, chemical composition and thicknesses of the coatings. The influence of coatings on magnetic properties in the frequency range of 50 – 2000 Hz was also measured.

Název v anglickém jazyce

Enhancement of Magnetic Properties of 41CrMo4 Steel by Means of Diffusion Coatings

Popis výsledku anglicky

The knowledge of magnetic and transport properties of construction steels for magnetic circuits plays an important role. Three different techniques: (i) flame spray, (ii) twin wire arc spray and (iii) powder mixture with halide activator were used to produce Si, CuSn6 and Si coatings, respectively, on the 41CrMo4 steel ring substrates. Immediately after the thermal spraying or inserting the steels into the powder mixture was used isothermal heat treatment at the temperatures of 800 °C / 6 hrs, 1000 °C / 4 hrs and 1250 °C / 2 hrs to produce the diffusion coatings. Several coating systems consisting of different phases and thicknesses were manufactured. Opto-digital microscope, scanning electron microscope and digital image analysis, second equipped with energy dispersive microanalyzer, were utilized to characterize the microstructure, chemical composition and thicknesses of the coatings. The influence of coatings on magnetic properties in the frequency range of 50 – 2000 Hz was also measured.

Druh

O - Ostatní výsledky

CEP obor

JK - Koroze a povrchové úpravy materiálu

OECD FORD obor

—

Projekt

Výsledek vznikl pri realizaci vícero projektů. Více informací v záložce Projekty.

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů