The Effect of Modification by Strontium of the AlSi7Mg0.3 Alloy on the Surface Roughness

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F13%3A43885351" target="_blank" >RIV/44555601:13420/13:43885351 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

The Effect of Modification by Strontium of the AlSi7Mg0.3 Alloy on the Surface Roughness

Popis výsledku v původním jazyce

Al-Si Alloys are a leading casting alloys based on aluminum. Machining of aluminum alloys is currently frequently used and it is an important area of production. The paper deals with an experiment, that was realized at the Faculty of Production Technology and Management, University of Jan Evangelista Purkyne in Ústí nad Labem, where was machined alloy AlSi7Mg0.3. Samples were made for machining because of the master alloys of AlSi7Mg0.3, where part of the castings was left in its original condition andpart of the castings was modified by strontium. This paper describes the evaluation of surface roughness obtained after machining of these castings in terms of how the modification by strontium can affect this.

Název v anglickém jazyce

The Effect of Modification by Strontium of the AlSi7Mg0.3 Alloy on the Surface Roughness

Popis výsledku anglicky

Al-Si Alloys are a leading casting alloys based on aluminum. Machining of aluminum alloys is currently frequently used and it is an important area of production. The paper deals with an experiment, that was realized at the Faculty of Production Technology and Management, University of Jan Evangelista Purkyne in Ústí nad Labem, where was machined alloy AlSi7Mg0.3. Samples were made for machining because of the master alloys of AlSi7Mg0.3, where part of the castings was left in its original condition andpart of the castings was modified by strontium. This paper describes the evaluation of surface roughness obtained after machining of these castings in terms of how the modification by strontium can affect this.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JG - Hutnictví, kovové materiály

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach<br>I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

13

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

380-384

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—