Cutting Tool Wear Monitoring

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F15%3A43887012" target="_blank" >RIV/44555601:13420/15:43887012 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Cutting Tool Wear Monitoring

Popis výsledku v původním jazyce

Cutting tool wear monitoring is one of key problems in automation of machining processes. Apart from the cutting tool wear monitoring for the cutting tool change and cutting tool failure, cutting tool wear monitoring may be one of the components for theadaptive control of a machining process. This paper is focused on the design of turning cutting tool wear sensors of the system flap - jet principal with increased extend. On the geometric principles in cutting with a turn-ing cutting tool, the relationsamong the output of jet mouth, clearance angle and cutting tool wear were expressed. Two variants of turning cutting tool sensors were designed and experimentally verified. The results of experiments have proved the possibility to apply cutting tool wear sensor of the system flap - jet principal with increased extend in practi-cal use.

Název v anglickém jazyce

Cutting Tool Wear Monitoring

Popis výsledku anglicky

Cutting tool wear monitoring is one of key problems in automation of machining processes. Apart from the cutting tool wear monitoring for the cutting tool change and cutting tool failure, cutting tool wear monitoring may be one of the components for theadaptive control of a machining process. This paper is focused on the design of turning cutting tool wear sensors of the system flap - jet principal with increased extend. On the geometric principles in cutting with a turn-ing cutting tool, the relationsamong the output of jet mouth, clearance angle and cutting tool wear were expressed. Two variants of turning cutting tool sensors were designed and experimentally verified. The results of experiments have proved the possibility to apply cutting tool wear sensor of the system flap - jet principal with increased extend in practi-cal use.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

15

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

380-384

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—