The Effect of Different Modifiers in AlSi7Mg0,3 Alloy on Built-up Edge Formation in Machining

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F16%3A43888035" target="_blank" >RIV/44555601:13420/16:43888035 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

The Effect of Different Modifiers in AlSi7Mg0,3 Alloy on Built-up Edge Formation in Machining

Popis výsledku v původním jazyce

Aluminium and silicon alloys are widely used in practice. But there is increasingly more emphasis placed on research and development of these materials. The aim of this article is to analyze modified aluminium alloy AlSi7Mg0,3. This article is focused on the effect of particular modifiers in AlSi7Mg0,3 alloy on built-up edge formation in machining. Four variants of castings (unmodified alloy and alloy modified by chemical elements - strontium, calcium and antimony) were used. All alloys were compared with non-modified alloy. There were moulded castings from each modified variant and the casting of non-modified alloy. It was casted using a gravity-die casting into a metal mould with a thermal insulation.

Název v anglickém jazyce

The Effect of Different Modifiers in AlSi7Mg0,3 Alloy on Built-up Edge Formation in Machining

Popis výsledku anglicky

Aluminium and silicon alloys are widely used in practice. But there is increasingly more emphasis placed on research and development of these materials. The aim of this article is to analyze modified aluminium alloy AlSi7Mg0,3. This article is focused on the effect of particular modifiers in AlSi7Mg0,3 alloy on built-up edge formation in machining. Four variants of castings (unmodified alloy and alloy modified by chemical elements - strontium, calcium and antimony) were used. All alloys were compared with non-modified alloy. There were moulded castings from each modified variant and the casting of non-modified alloy. It was casted using a gravity-die casting into a metal mould with a thermal insulation.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

173-178

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—