Analysis of machinability of new AlSi7Mg0.3 alloys with different calcium content

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F44555601%3A13420%2F18%3A43894233" target="_blank" >RIV/44555601:13420/18:43894233 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Analysis of machinability of new AlSi7Mg0.3 alloys with different calcium content

Popis výsledku v původním jazyce

The field of application of aluminium alloys is very wide and the future use of aluminium alloys is related to the further development of new alloys. Recently, the use of alloys in aluminium alloys is a trend in achieving changes in chemical, mechanical and technological properties. This paper deals with the investigation of the area of calcium influence, especially on the machinability of the alloy. The analysis was performed by alloying AlSi7Mg0.3 with master alloy AlCa10. Four types of samples with different calcium content, from at least 0.1% Ca, up to 1% Ca maximum, were produced. In the case of such samples, research was carried out on the technological properties and especially the workability.

Název v anglickém jazyce

Analysis of machinability of new AlSi7Mg0.3 alloys with different calcium content

Popis výsledku anglicky

The field of application of aluminium alloys is very wide and the future use of aluminium alloys is related to the further development of new alloys. Recently, the use of alloys in aluminium alloys is a trend in achieving changes in chemical, mechanical and technological properties. This paper deals with the investigation of the area of calcium influence, especially on the machinability of the alloy. The analysis was performed by alloying AlSi7Mg0.3 with master alloy AlCa10. Four types of samples with different calcium content, from at least 0.1% Ca, up to 1% Ca maximum, were produced. In the case of such samples, research was carried out on the technological properties and especially the workability.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20501 - Materials engineering

Projekt

—

Návaznosti

V - Vyzkumna aktivita podporovana z jinych verejnych zdroju

Rok uplatnění

2018

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

18

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

7

Strana od-do

679-685

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85058004195