Využití vtokové soustavy s uzavíratelnými tryskami u family nástrojů při vstřikování

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F07%3A%40KSP0218" target="_blank" >RIV/46747885:24210/07:@KSP0218 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Employment the Feed System with Closable Edges by Family Moulds in Injection Technology

Popis výsledku v původním jazyce

The injection technology of polymers is getting to the top of the technologies. Continual increasing requirements on product properties however bring also the increasing requirements on injection technology. Except of quality and technological point of view there is also the economical standpoint, which heads for the most possible profitable production. In the case of large-lot production is advantage to use the multicavity moulds, where is possible to fabricate over a hundred products in one shot. Recently gets in to the front also usage of the family moulds, which are applied in large-lot production, when the final product is assembled of more partial injected parts. Such moulds enjoy an advantage of production the different part in one injection cycle. There is used only one mould with more different cavities for the parts instead of many individual injection moulds. Usage of family moulds with closable edges feed system is described in the report.

Název v anglickém jazyce

Employment the Feed System with Closable Edges by Family Moulds in Injection Technology

Popis výsledku anglicky

The injection technology of polymers is getting to the top of the technologies. Continual increasing requirements on product properties however bring also the increasing requirements on injection technology. Except of quality and technological point of view there is also the economical standpoint, which heads for the most possible profitable production. In the case of large-lot production is advantage to use the multicavity moulds, where is possible to fabricate over a hundred products in one shot. Recently gets in to the front also usage of the family moulds, which are applied in large-lot production, when the final product is assembled of more partial injected parts. Such moulds enjoy an advantage of production the different part in one injection cycle. There is used only one mould with more different cavities for the parts instead of many individual injection moulds. Usage of family moulds with closable edges feed system is described in the report.

Druh

D - Stať ve sborníku

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2007

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Erin 2007

ISBN

978-80-227-2636-8

ISSN

—

e-ISSN

—

Počet stran výsledku

3

Strana od-do

—

Název nakladatele

Slovak University of Technology in Bratislava

Místo vydání

Bratislava

Místo konání akce

Bratislava

Datum konání akce

25. 4. 2007

Typ akce podle státní příslušnosti

EUR - Evropská akce

Kód UT WoS článku

—