Air overpressure in mould cavity influence on injection molded parts mechanical and surface properties.

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F10%3A%230001562" target="_blank" >RIV/46747885:24210/10:#0001562 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Air overpressure in mould cavity influence on injection molded parts mechanical and surface properties.

Popis výsledku v původním jazyce

Plastics injection molding process is possible to optimize from many points of view. Main goal of this optimization is to short cycle time and improve injection molded parts properties such a mechanical, optical, electrical or surface properties where issurface quality without sink marks very important. Abstract of the paper should have approximately ten lines and must be written in world language. Goal of this paper is to present injection molding process innovation evolved on Technical university ofLiberec possible contributions. This innovation consists in air overpressure setting in mould cavity from injection phase beginning. Basic supposition is to partly substitute conventional holding phase which is standardly beginning up to injection phase.Effect of this can be in cycle time shortening because of shorter conventional holding phase time or improved injection molded parts properties because of volume affected by holding phase rather by processes ongoing during holding phase

Název v anglickém jazyce

Air overpressure in mould cavity influence on injection molded parts mechanical and surface properties.

Popis výsledku anglicky

Plastics injection molding process is possible to optimize from many points of view. Main goal of this optimization is to short cycle time and improve injection molded parts properties such a mechanical, optical, electrical or surface properties where issurface quality without sink marks very important. Abstract of the paper should have approximately ten lines and must be written in world language. Goal of this paper is to present injection molding process innovation evolved on Technical university ofLiberec possible contributions. This innovation consists in air overpressure setting in mould cavity from injection phase beginning. Basic supposition is to partly substitute conventional holding phase which is standardly beginning up to injection phase.Effect of this can be in cycle time shortening because of shorter conventional holding phase time or improved injection molded parts properties because of volume affected by holding phase rather by processes ongoing during holding phase

Druh

D - Stať ve sborníku

CEP obor

JP - Průmyslové procesy a zpracování

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

ME2010 full paper proceedings

ISBN

978-80-227-3304-5

ISSN

—

e-ISSN

—

Počet stran výsledku

6

Strana od-do

—

Název nakladatele

FME SUT, Bratislava

Místo vydání

Bratislava

Místo konání akce

Bratislava

Datum konání akce

21. 10. 2010

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—