Cutting Tool Wear Determination by Measuring Tool Shank Deformation

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F11%3A%230002621" target="_blank" >RIV/46747885:24210/11:#0002621 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Cutting Tool Wear Determination by Measuring Tool Shank Deformation

Popis výsledku v původním jazyce

This article shows on possibility to use direct measurement of the tool shank deformation for determination the state of the cutting edge. It is well known that cutting forces are changing with the tool wear. But the changes are not linear and it is verydifficult to use a selected force for effective monitoring. Therefoe the ratio of forces could be possibel to give necessary information. For the forces measurement it is necessary to use dynamometer and this one is undesirable for use in shop floor. Therefore it was used for solution the ratio of deformation created by cutting forces on the body of the tool shank. Deformations of the turning tool were measured on the all four surfaces of the shank body in close propinquity og the cutting tool nose. Outcomes of the research shown in the presented contribution give optimistic result.

Název v anglickém jazyce

Cutting Tool Wear Determination by Measuring Tool Shank Deformation

Popis výsledku anglicky

This article shows on possibility to use direct measurement of the tool shank deformation for determination the state of the cutting edge. It is well known that cutting forces are changing with the tool wear. But the changes are not linear and it is verydifficult to use a selected force for effective monitoring. Therefoe the ratio of forces could be possibel to give necessary information. For the forces measurement it is necessary to use dynamometer and this one is undesirable for use in shop floor. Therefore it was used for solution the ratio of deformation created by cutting forces on the body of the tool shank. Deformations of the turning tool were measured on the all four surfaces of the shank body in close propinquity og the cutting tool nose. Outcomes of the research shown in the presented contribution give optimistic result.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2011

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Strojírenská technologie

ISSN

1211-4162

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

59-64

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—