Assessment of the procedural gases influence at turning technology

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F16%3A00003137" target="_blank" >RIV/46747885:24210/16:00003137 - isvavai.cz</a>

Výsledek na webu

<a href="http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-1.pdf" target="_blank" >http://journal.strojirenskatechnologie.cz/templates/obalky_casopis/XVI_2016-1.pdf</a>

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Assessment of the procedural gases influence at turning technology

Popis výsledku v původním jazyce

This paper deals with the assessment of the procedural gases progressive cooling methods and cooling by procedural liquids at turning technology on the final workpiece surface quality. Turning by using liquefied CO2, liquefied nitrogen and subcooled air supplied through the vortex tube was compared with the turning without process medium (taken as reference conditions) and with two procedural liquids EOPS 1030 and HOCUT 795 B. At evaluation effect of procedural gases there were monitored acting forces, cutting tool cooling rate and the machined layer of the material, cutting tool durability and cut surface quality which was characterized by surface roughness and dimensional accuracy. During the experimental part there were used devices as lathe SU50, piezoelectric dynamometer, the evaluation unit and profilometer. This issue was solved within solving the project TACR -TA03010492.

Název v anglickém jazyce

Assessment of the procedural gases influence at turning technology

Popis výsledku anglicky

This paper deals with the assessment of the procedural gases progressive cooling methods and cooling by procedural liquids at turning technology on the final workpiece surface quality. Turning by using liquefied CO2, liquefied nitrogen and subcooled air supplied through the vortex tube was compared with the turning without process medium (taken as reference conditions) and with two procedural liquids EOPS 1030 and HOCUT 795 B. At evaluation effect of procedural gases there were monitored acting forces, cutting tool cooling rate and the machined layer of the material, cutting tool durability and cut surface quality which was characterized by surface roughness and dimensional accuracy. During the experimental part there were used devices as lathe SU50, piezoelectric dynamometer, the evaluation unit and profilometer. This issue was solved within solving the project TACR -TA03010492.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

7

Strana od-do

162-168

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-84976470377