Strength of the adhesive joints at the car-body parts from the ahss with al-si coating

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F17%3A00004702" target="_blank" >RIV/46747885:24210/17:00004702 - isvavai.cz</a>

Výsledek na webu

<a href="http://dx.doi.org/10.17973/MMSJ.2017_11_201750" target="_blank" >http://dx.doi.org/10.17973/MMSJ.2017_11_201750</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2017_11_201750" target="_blank" >10.17973/MMSJ.2017_11_201750</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Strength of the adhesive joints at the car-body parts from the ahss with al-si coating

Popis výsledku v původním jazyce

The paper deals with the monitoring the utility properties of the Al-Si coating which is applied by means of the hot dip coating on the ultra-high strength sheet 22MnB5 (martensite steel alloyed by boron). These sheets are used at the car-body design as the safety elements (bumpers, reinforcement posts). Individual parts are jointed also by the adhesive bonding methods. Evaluation of the material surface protection layers is carried out in dependence on the time of material heating in the furnace during thermal treatment and subsequent influence of this layer on the adhesive joint strength and failure pattern. To compare adhesive joint strength is used epoxy adhesive from two producers. Results provide information about behavior of the ultra-high strength sheets adhesive joints strength properties as a criterion for suitability to apply coatings AlSi in the series production of cars.

Název v anglickém jazyce

Strength of the adhesive joints at the car-body parts from the ahss with al-si coating

Popis výsledku anglicky

The paper deals with the monitoring the utility properties of the Al-Si coating which is applied by means of the hot dip coating on the ultra-high strength sheet 22MnB5 (martensite steel alloyed by boron). These sheets are used at the car-body design as the safety elements (bumpers, reinforcement posts). Individual parts are jointed also by the adhesive bonding methods. Evaluation of the material surface protection layers is carried out in dependence on the time of material heating in the furnace during thermal treatment and subsequent influence of this layer on the adhesive joint strength and failure pattern. To compare adhesive joint strength is used epoxy adhesive from two producers. Results provide information about behavior of the ultra-high strength sheets adhesive joints strength properties as a criterion for suitability to apply coatings AlSi in the series production of cars.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20506 - Coating and films

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

18031269

e-ISSN

—

Svazek periodika

Vol. 2017

Číslo periodika v rámci svazku

November

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

4

Strana od-do

1901-1904

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85034646536