Fractographical Analysis of Screws Used for Truck Cab Holding

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F17%3A00004825" target="_blank" >RIV/46747885:24210/17:00004825 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/46747885:24620/17:00004825

Výsledek na webu

<a href="https://www.scientific.net/SSP.270.52" target="_blank" >https://www.scientific.net/SSP.270.52</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.4028/www.scientific.net/SSP.270.52" target="_blank" >10.4028/www.scientific.net/SSP.270.52</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Fractographical Analysis of Screws Used for Truck Cab Holding

Popis výsledku v původním jazyce

Many of currently manufactured components intended for automotive, must not only meet the requirements on functionality, but also considerable demands on the visual appearance. Parts are subjected to thorough inspection and suppliers are forced to deal with causes of a very slight visual defects. When examining the defects, it is necessary to use a whole range of advanced analytical methods and procedures previously used only for identification of the physical and chemical properties and structure of the material. This paper deals with several examples which have been solved. It focuses especially on the use of demanding metallographic sample preparation from components with surface defects, examining the defects on the cross-section using mainly microscopic techniques and determining the causes of their generation. These results then serve as a basis for modification of the technology and thus they are the tool for significant reduction of amount of NOK parts

Název v anglickém jazyce

Fractographical Analysis of Screws Used for Truck Cab Holding

Popis výsledku anglicky

Many of currently manufactured components intended for automotive, must not only meet the requirements on functionality, but also considerable demands on the visual appearance. Parts are subjected to thorough inspection and suppliers are forced to deal with causes of a very slight visual defects. When examining the defects, it is necessary to use a whole range of advanced analytical methods and procedures previously used only for identification of the physical and chemical properties and structure of the material. This paper deals with several examples which have been solved. It focuses especially on the use of demanding metallographic sample preparation from components with surface defects, examining the defects on the cross-section using mainly microscopic techniques and determining the causes of their generation. These results then serve as a basis for modification of the technology and thus they are the tool for significant reduction of amount of NOK parts

Druh

D - Stať ve sborníku

CEP obor

—

OECD FORD obor

20306 - Audio engineering, reliability analysis

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

Solid State Phenomena

ISBN

9783035712414

ISSN

1662-9779

e-ISSN

—

Počet stran výsledku

5

Strana od-do

52-56

Název nakladatele

Trans Tech Publications Inc.

Místo vydání

Zurich

Místo konání akce

Mariánské Lázně

Datum konání akce

1. 1. 2017

Typ akce podle státní příslušnosti

CST - Celostátní akce

Kód UT WoS článku

—