Analysis of the pressure and shrinkage in the mould for PLA and PLLA
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F18%3A00006093" target="_blank" >RIV/46747885:24210/18:00006093 - isvavai.cz</a>
Výsledek na webu
<a href="http://dx.doi.org/10.4028/www.scientific.net/MSF.919.128" target="_blank" >http://dx.doi.org/10.4028/www.scientific.net/MSF.919.128</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.4028/www.scientific.net/MSF.919.128" target="_blank" >10.4028/www.scientific.net/MSF.919.128</a>
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Analysis of the pressure and shrinkage in the mould for PLA and PLLA
Popis výsledku v původním jazyce
Paper is focused on analysis of a local shrinkage and injection pressure of the biodegradable materials PLLA and PLA. Analysed products were prepared with thickness of 4 mm in the patent injection mould. The technological parameters of the injection moulding were established by the Taguchi method. In this article, the influence of these main technological parameters on the local shrinkage and injection pressure is evaluated.
Název v anglickém jazyce
Analysis of the pressure and shrinkage in the mould for PLA and PLLA
Popis výsledku anglicky
Paper is focused on analysis of a local shrinkage and injection pressure of the biodegradable materials PLLA and PLA. Analysed products were prepared with thickness of 4 mm in the patent injection mould. The technological parameters of the injection moulding were established by the Taguchi method. In this article, the influence of these main technological parameters on the local shrinkage and injection pressure is evaluated.
Klasifikace
Druh
D - Stať ve sborníku
CEP obor
—
OECD FORD obor
20903 - Bioproducts (products that are manufactured using biological material as feedstock) biomaterials, bioplastics, biofuels, bioderived bulk and fine chemicals, bio-derived novel materials
Návaznosti výsledku
Projekt
—
Návaznosti
I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace
Ostatní
Rok uplatnění
2018
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název statě ve sborníku
Materials Science Forum
ISBN
—
ISSN
02555476
e-ISSN
—
Počet stran výsledku
7
Strana od-do
128-135
Název nakladatele
Trans Tech Publications Ltd
Místo vydání
—
Místo konání akce
neuvedeno
Datum konání akce
1. 1. 2017
Typ akce podle státní příslušnosti
WRD - Celosvětová akce
Kód UT WoS článku
—