Influence of Heat Treatment on the change of Al-Si Coating Properties at Ultra-high Strength Sheets

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F19%3A00005958" target="_blank" >RIV/46747885:24210/19:00005958 - isvavai.cz</a>

Výsledek na webu

<a href="https://arl.ujep.cz/arl-ujep/cs/csg/?repo=ujeprepo&key=92437028857" target="_blank" >https://arl.ujep.cz/arl-ujep/cs/csg/?repo=ujeprepo&key=92437028857</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.21062/ujep/247.2019/a/1213-2489/mt/19/1/77" target="_blank" >10.21062/ujep/247.2019/a/1213-2489/mt/19/1/77</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of Heat Treatment on the change of Al-Si Coating Properties at Ultra-high Strength Sheets

Popis výsledku v původním jazyce

Paper deals with the evaluation of protective coating surface layer Al-Si at boron steel 22MnB5. Parts from these steels are used at the car-body design. Such parts are produced by hot forming technology that means not only higher requirements on material but also on the surface layer. Coatings are used to protect surface against oxidation during heating and also support the own forming process inside the tools. In this paper is evaluated the protective layer change during heat treatment - heating in furnace (8, 12 and 16 min). Performed microscopic analysis of Al-Si surface layer proves the thermal regime influence on the change of coating properties.

Název v anglickém jazyce

Influence of Heat Treatment on the change of Al-Si Coating Properties at Ultra-high Strength Sheets

Popis výsledku anglicky

Paper deals with the evaluation of protective coating surface layer Al-Si at boron steel 22MnB5. Parts from these steels are used at the car-body design. Such parts are produced by hot forming technology that means not only higher requirements on material but also on the surface layer. Coatings are used to protect surface against oxidation during heating and also support the own forming process inside the tools. In this paper is evaluated the protective layer change during heat treatment - heating in furnace (8, 12 and 16 min). Performed microscopic analysis of Al-Si surface layer proves the thermal regime influence on the change of coating properties.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20501 - Materials engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2019

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

19

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

77-81

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85063317884