Quantitative assessment of the causes of the strengthening of a machined surface after cutting

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24210%2F20%3A00008245" target="_blank" >RIV/46747885:24210/20:00008245 - isvavai.cz</a>

Výsledek na webu

<a href="http://www.inderscience.com/offer.php?id=110535" target="_blank" >http://www.inderscience.com/offer.php?id=110535</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.1504/IJSURFSE.2020.110535" target="_blank" >10.1504/IJSURFSE.2020.110535</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Quantitative assessment of the causes of the strengthening of a machined surface after cutting

Popis výsledku v původním jazyce

Plastic deformation of the surface layer leads to strengthening, i.e., to a change in the mechanical properties of the machined surface material. The strengthening of the surface parts directly affects the life cycle of the finished product. This study focuses on the quality management of the machined surface after machining of structural and stainless steels. The purpose of this study was to identify the strengthening degree of the machined surface due to processes occurring in the chip formation zone and on the rear surface of the cutting tool. This study has, produced a quantitative assessment of the causes for the increase in microhardness as a result of the force during the passing of the future surface layer through the plastic deformation area that develops in the chip formation zone and the plastic deformation produced by the impact of the rear surface of the cutting tool on the machined surface.

Název v anglickém jazyce

Quantitative assessment of the causes of the strengthening of a machined surface after cutting

Popis výsledku anglicky

Plastic deformation of the surface layer leads to strengthening, i.e., to a change in the mechanical properties of the machined surface material. The strengthening of the surface parts directly affects the life cycle of the finished product. This study focuses on the quality management of the machined surface after machining of structural and stainless steels. The purpose of this study was to identify the strengthening degree of the machined surface due to processes occurring in the chip formation zone and on the rear surface of the cutting tool. This study has, produced a quantitative assessment of the causes for the increase in microhardness as a result of the force during the passing of the future surface layer through the plastic deformation area that develops in the chip formation zone and the plastic deformation produced by the impact of the rear surface of the cutting tool on the machined surface.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2020

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

International Journal of Surface Science and Engineering

ISSN

1749-785X

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

3

Stát vydavatele periodika

CH - Švýcarská konfederace

Počet stran výsledku

16

Strana od-do

207-222

Kód UT WoS článku

000586474100003

EID výsledku v databázi Scopus

2-s2.0-85095436130