Warming of Mould by Infraheaters in the Car Industry

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24220%2F11%3A%230001794" target="_blank" >RIV/46747885:24220/11:#0001794 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Warming of Mould by Infraheaters in the Car Industry

Popis výsledku v původním jazyce

The article is focused on the calculation of the heat radiation intensity on an aluminium mould surface intended for the production of artificial leather in the car industry (e.g. the artificial leather on a car dashboard). The mould surface is sprinkledwith a special material and is heated by infra heaters located above the mould, up to a temperature of 250°C. Concurrently, it is necessary to carry out the configuration of the infra heaters locations above the mould in such way that the heat radiationintensity on the mould surface is approximately the same, and by this way, a similar structure and colour for the whole surface of leather is ensured. The mould surface is described by its elementary surfaces. The practical realisation of the suitable setting of the infra heaters above the mould is rather time-consuming. The procedure for the heat radiation intensity calculation on a particular mould surface for the respective location of infra heaters is described in the paper. Experim

Název v anglickém jazyce

Warming of Mould by Infraheaters in the Car Industry

Popis výsledku anglicky

The article is focused on the calculation of the heat radiation intensity on an aluminium mould surface intended for the production of artificial leather in the car industry (e.g. the artificial leather on a car dashboard). The mould surface is sprinkledwith a special material and is heated by infra heaters located above the mould, up to a temperature of 250°C. Concurrently, it is necessary to carry out the configuration of the infra heaters locations above the mould in such way that the heat radiationintensity on the mould surface is approximately the same, and by this way, a similar structure and colour for the whole surface of leather is ensured. The mould surface is described by its elementary surfaces. The practical realisation of the suitable setting of the infra heaters above the mould is rather time-consuming. The procedure for the heat radiation intensity calculation on a particular mould surface for the respective location of infra heaters is described in the paper. Experim

Druh

D - Stať ve sborníku

CEP obor

BC - Teorie a systémy řízení

OECD FORD obor

—

Projekt

<a href="/cs/project/FR-TI1%2F266" target="_blank" >FR-TI1/266: *Inovace technologie výroby umělých kůží</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2011

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

10th International Workshop on Electronics, Control, Measurement and Signals

ISBN

978-1-61284-395-7

ISSN

—

e-ISSN

—

Počet stran výsledku

5

Strana od-do

67-71

Název nakladatele

TU Liberec

Místo vydání

Liberec

Místo konání akce

Liberec

Datum konání akce

1. 1. 2011

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—