SIMULATION OF AIRFLOW MOTION IN JET NOZZLE WITH DIFFERENT TANGENTIALLY INJECTED ORIFICE PARAMETERS

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24410%2F12%3A%230001287" target="_blank" >RIV/46747885:24410/12:#0001287 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

SIMULATION OF AIRFLOW MOTION IN JET NOZZLE WITH DIFFERENT TANGENTIALLY INJECTED ORIFICE PARAMETERS

Popis výsledku v původním jazyce

FLUENT software program is used to simulate and analysis the motion of airflow in jet nozzle which is applied in spinning technology. The understanding of airflow motion is helpful for modifying the structure of nozzle which is closely related to the yarn properties and productivity. In this work, different orifice (tangentially injected) number and diameter are studied. The results showed that the velocities increase as the orifice number and diameter. Therefore, the nozzle with more orifices and lagerdiameter increases the utilization ratio of energy, can produce better yarn, as well as the higher production efficiency. But on the other hand, the cost of nozzle with more orifice increases and the precision of nozzle decrease due to the difficulty ofnozzle manufacturing.

Název v anglickém jazyce

SIMULATION OF AIRFLOW MOTION IN JET NOZZLE WITH DIFFERENT TANGENTIALLY INJECTED ORIFICE PARAMETERS

Popis výsledku anglicky

FLUENT software program is used to simulate and analysis the motion of airflow in jet nozzle which is applied in spinning technology. The understanding of airflow motion is helpful for modifying the structure of nozzle which is closely related to the yarn properties and productivity. In this work, different orifice (tangentially injected) number and diameter are studied. The results showed that the velocities increase as the orifice number and diameter. Therefore, the nozzle with more orifices and lagerdiameter increases the utilization ratio of energy, can produce better yarn, as well as the higher production efficiency. But on the other hand, the cost of nozzle with more orifice increases and the precision of nozzle decrease due to the difficulty ofnozzle manufacturing.

Druh

D - Stať ve sborníku

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2012

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

19th Strutex

ISBN

978-80-7372-913-4

ISSN

—

e-ISSN

—

Počet stran výsledku

8

Strana od-do

—

Název nakladatele

Technická univerzita v Liberci

Místo vydání

Liberec

Místo konání akce

Liberec

Datum konání akce

3. 12. 2012

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—