Surface modification of polymer optical fibers for enhanced side emission behavior

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F46747885%3A24410%2F13%3A%230001654" target="_blank" >RIV/46747885:24410/13:#0001654 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Surface modification of polymer optical fibers for enhanced side emission behavior

Popis výsledku v původním jazyce

Original abstract The polymer optical fiber with trade name Flexi was used in this research, because of its flexibility and the range of diameters available in the market. These fibers were dyed using commercial disperse dye under various conditions of dye concentration and dyeing time. Samples were analyzed for side emission of light with the use of an instrument which was specifically designed for the measurement of this nature. The results showed that the dye penetration is dependent on time, if dyeconcentration and temperature are kept constant. After 40 min of dyeing, the fiber core showed an increase in side emission with lower loss due to attenuation. Excessive time in the hot conditions also degraded the fiber, so that the fiber became very stiff and brittle. Fibers were also subjected to heat, in the form of boiling water bath, for selected periods of time, and it was found that the effect was similar to that of the prior experiments. Surface treatment of Flexi fibers was car

Název v anglickém jazyce

Surface modification of polymer optical fibers for enhanced side emission behavior

Popis výsledku anglicky

Original abstract The polymer optical fiber with trade name Flexi was used in this research, because of its flexibility and the range of diameters available in the market. These fibers were dyed using commercial disperse dye under various conditions of dye concentration and dyeing time. Samples were analyzed for side emission of light with the use of an instrument which was specifically designed for the measurement of this nature. The results showed that the dye penetration is dependent on time, if dyeconcentration and temperature are kept constant. After 40 min of dyeing, the fiber core showed an increase in side emission with lower loss due to attenuation. Excessive time in the hot conditions also degraded the fiber, so that the fiber became very stiff and brittle. Fibers were also subjected to heat, in the form of boiling water bath, for selected periods of time, and it was found that the effect was similar to that of the prior experiments. Surface treatment of Flexi fibers was car

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JJ - Ostatní materiály

OECD FORD obor

—

Projekt

—

Návaznosti

I - Institucionalni podpora na dlouhodoby koncepcni rozvoj vyzkumne organizace

Rok uplatnění

2013

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Fibers and Polymers

ISSN

1875-0052

e-ISSN

—

Svazek periodika

14

Číslo periodika v rámci svazku

9

Stát vydavatele periodika

KR - Korejská republika

Počet stran výsledku

4

Strana od-do

1468-1471

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—