Results obtained in the postprocessing of NC programs in a CAD/CAM system by means of 2- to5- axis postprocessors at the University of West Bohemia

Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F03%3A00000081" target="_blank" >RIV/49777513:23210/03:00000081 - isvavai.cz</a>
Výsledek na webu
—
DOI - Digital Object Identifier
—

Jazyk výsledku
angličtina
Název v původním jazyce
Results obtained in the postprocessing of NC programs in a CAD/CAM system by means of 2- to5- axis postprocessors at the University of West Bohemia
Popis výsledku v původním jazyce
In the introduction the paper defines fundamental terms concerning postprocessor. Various methods used in the development of postprocessors are described in the following part. The main part of the paper describes the programming of postprocessors in the CAD/CAM systems Pro/ENGINEER, Cimatron at UWB in Pilsen and their use in the solution of practical tasks.
Název v anglickém jazyce
Results obtained in the postprocessing of NC programs in a CAD/CAM system by means of 2- to5- axis postprocessors at the University of West Bohemia
Popis výsledku anglicky
In the introduction the paper defines fundamental terms concerning postprocessor. Various methods used in the development of postprocessors are described in the following part. The main part of the paper describes the programming of postprocessors in the CAD/CAM systems Pro/ENGINEER, Cimatron at UWB in Pilsen and their use in the solution of practical tasks.

Rok uplatnění
2003
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Podobné výsledky(10)