Tool wear influence on cutting forces at hard HSC milling with cutting ceramics

Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F09%3A00501835" target="_blank" >RIV/49777513:23210/09:00501835 - isvavai.cz</a>
Výsledek na webu
—
DOI - Digital Object Identifier
—

Jazyk výsledku
angličtina
Název v původním jazyce
Tool wear influence on cutting forces at hard HSC milling with cutting ceramics
Popis výsledku v původním jazyce
The article deals with the relationship between tool wear and cutting forces at hard HSC milling. Attention is also given to the comparison of the three sorts (grades) of the cutting ceramics. The cutting ceramics are tested at various cutting speeds andtypes of milling. The cutting conditions were chosen 5 - 10 times higher the conventional cutting conditions. The article brings a new view on the behaviour of cutting ceramics under extreme conditions.
Název v anglickém jazyce
Tool wear influence on cutting forces at hard HSC milling with cutting ceramics
Popis výsledku anglicky
The article deals with the relationship between tool wear and cutting forces at hard HSC milling. Attention is also given to the comparison of the three sorts (grades) of the cutting ceramics. The cutting ceramics are tested at various cutting speeds andtypes of milling. The cutting conditions were chosen 5 - 10 times higher the conventional cutting conditions. The article brings a new view on the behaviour of cutting ceramics under extreme conditions.

Rok uplatnění
2009
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Podobné výsledky(10)