Effect of cutting edge geometry on cutting forces when drilling Inconel 718

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F17%3A43931502" target="_blank" >RIV/49777513:23210/17:43931502 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Effect of cutting edge geometry on cutting forces when drilling Inconel 718

Popis výsledku v původním jazyce

This work deals with the problematics of cutting forces when drilling holes in Inconel 718. Drills with different geometries of cutting edge were used. The cutting forces and torques were measured during the experiment. The feed cutting force had the greatest influence of all the cutting forces, therefore only the cutting force feed was evaluated. The torque was monitored. This material is known for its unique properties of high strength at high temperatures, corrosion resistance, high hardness, work hardening and low thermal conductivity. Part of the paper is focused on the experiment where the effects of the geometry of the cutting edge on cutting forces are evaluated. This paper is limited only to carbide tools. The results of the experiment are compared with results from other research institute.

Název v anglickém jazyce

Effect of cutting edge geometry on cutting forces when drilling Inconel 718

Popis výsledku anglicky

This work deals with the problematics of cutting forces when drilling holes in Inconel 718. Drills with different geometries of cutting edge were used. The cutting forces and torques were measured during the experiment. The feed cutting force had the greatest influence of all the cutting forces, therefore only the cutting force feed was evaluated. The torque was monitored. This material is known for its unique properties of high strength at high temperatures, corrosion resistance, high hardness, work hardening and low thermal conductivity. Part of the paper is focused on the experiment where the effects of the geometry of the cutting edge on cutting forces are evaluated. This paper is limited only to carbide tools. The results of the experiment are compared with results from other research institute.

Druh

J_SC - Článek v periodiku v databázi SCOPUS

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

<a href="/cs/project/LO1502" target="_blank" >LO1502: Rozvoj Regionálního technologického institutu</a><br>

Návaznosti

P - Projekt vyzkumu a vyvoje financovany z verejnych zdroju (s odkazem do CEP)

Rok uplatnění

2017

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

17

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

24-29

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85013802781