The immersion depth influences on cutting edge radius during drag finishing
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F17%3A43932904" target="_blank" >RIV/49777513:23210/17:43932904 - isvavai.cz</a>
Výsledek na webu
<a href="http://dx.doi.org/10.2507/28th.daaam.proceedings.143" target="_blank" >http://dx.doi.org/10.2507/28th.daaam.proceedings.143</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.2507/28th.daaam.proceedings.143" target="_blank" >10.2507/28th.daaam.proceedings.143</a>
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
The immersion depth influences on cutting edge radius during drag finishing
Popis výsledku v původním jazyce
The article deals with the intensity of the preparation of a cutting edge during the drag finishing process. The cutting edge radius of a milling tool is investigated because it is a very important element of cutting tool behaviour during machining. The intensity of the process was evaluated relative to the immersion depths of samples during drag finishing. The aim of this experiment is to confirm the idea that a greater depth in the working container causes a higher intensity of the process. A DF – 3 drag finishing machine was used for the experiment. An Alicona IFM G4 microscope was used to measure the microgeometry of the cutting edges. Cutting edges were always measured before and after the modification. The main goal of this article is to find the dependence between cutting edge modification intensity and immersion depth.
Název v anglickém jazyce
The immersion depth influences on cutting edge radius during drag finishing
Popis výsledku anglicky
The article deals with the intensity of the preparation of a cutting edge during the drag finishing process. The cutting edge radius of a milling tool is investigated because it is a very important element of cutting tool behaviour during machining. The intensity of the process was evaluated relative to the immersion depths of samples during drag finishing. The aim of this experiment is to confirm the idea that a greater depth in the working container causes a higher intensity of the process. A DF – 3 drag finishing machine was used for the experiment. An Alicona IFM G4 microscope was used to measure the microgeometry of the cutting edges. Cutting edges were always measured before and after the modification. The main goal of this article is to find the dependence between cutting edge modification intensity and immersion depth.
Klasifikace
Druh
D - Stať ve sborníku
CEP obor
—
OECD FORD obor
20301 - Mechanical engineering
Návaznosti výsledku
Projekt
—
Návaznosti
S - Specificky vyzkum na vysokych skolach
Ostatní
Rok uplatnění
2017
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název statě ve sborníku
Proceedings of the 28th DAAAAM International Symposium
ISBN
978-3-902734-11-2
ISSN
1726-9679
e-ISSN
neuvedeno
Počet stran výsledku
7
Strana od-do
1030-1036
Název nakladatele
Danube Adria Association for Automation and Manufacturing, DAAAM
Místo vydání
Vienna
Místo konání akce
Zadar
Datum konání akce
8. 11. 2017
Typ akce podle státní příslušnosti
WRD - Celosvětová akce
Kód UT WoS článku
—