Removable Mounting of the Rolling Machines’ Working Rolls

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23210%2F21%3A43960291" target="_blank" >RIV/49777513:23210/21:43960291 - isvavai.cz</a>

Výsledek na webu

<a href="https://www.mmscience.eu/journal/issues/march-2021/articles/removable-mounting-of-the-rolling-machines-working-rolls" target="_blank" >https://www.mmscience.eu/journal/issues/march-2021/articles/removable-mounting-of-the-rolling-machines-working-rolls</a>

DOI - Digital Object Identifier

<a href="http://dx.doi.org/10.17973/MMSJ.2021_03_2021002" target="_blank" >10.17973/MMSJ.2021_03_2021002</a>

Jazyk výsledku

angličtina

Název v původním jazyce

Removable Mounting of the Rolling Machines’ Working Rolls

Popis výsledku v původním jazyce

The work is focused on the design solution of the method of removing the work rolls from the rolling mill for transverse wedge rolling. The tools are clamped to the cylinders. In case of technology change, the tools must be replaced. Tools can be changed directly on the machine, this is a non-productive time. Another way to change tools is to replace entire cylinders. The diameter of the rollers is large, so the rollers themselves cannot be pulled out through the side hole, as is the case with a rolling mill. There are several ways to connect the middle part of the cylinders to the pins located in the stands. The work compares connections with a lid and a square or cylindrical shaft and variants in a single-sided extension able shaft with a conical or spherical surface. The aim of the work is to compare the stiffness of connection methods.

Název v anglickém jazyce

Removable Mounting of the Rolling Machines’ Working Rolls

Popis výsledku anglicky

The work is focused on the design solution of the method of removing the work rolls from the rolling mill for transverse wedge rolling. The tools are clamped to the cylinders. In case of technology change, the tools must be replaced. Tools can be changed directly on the machine, this is a non-productive time. Another way to change tools is to replace entire cylinders. The diameter of the rollers is large, so the rollers themselves cannot be pulled out through the side hole, as is the case with a rolling mill. There are several ways to connect the middle part of the cylinders to the pins located in the stands. The work compares connections with a lid and a square or cylindrical shaft and variants in a single-sided extension able shaft with a conical or spherical surface. The aim of the work is to compare the stiffness of connection methods.

Druh

J_imp - Článek v periodiku v databázi Web of Science

CEP obor

—

OECD FORD obor

20301 - Mechanical engineering

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2021

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

MM Science Journal

ISSN

1803-1269

e-ISSN

—

Svazek periodika

2021

Číslo periodika v rámci svazku

March

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

6

Strana od-do

4310-4315

Kód UT WoS článku

000634572700012

EID výsledku v databázi Scopus

2-s2.0-85102778706