Deformation of print PLA material depending on the temperature of reheating printing pad

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F49777513%3A23420%2F16%3A43928560" target="_blank" >RIV/49777513:23420/16:43928560 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Deformation of print PLA material depending on the temperature of reheating printing pad

Popis výsledku v původním jazyce

This article presents results of partial research aimed at the prototyping - 3D printing. The authors focus on material polylactic acid (PLA) which is widely used for the manufacture of components using 3D printing. Technology of gradual laying of plastic layers causes tension and subsequently deformation of a printed components. This can lead to the tearing of the product from the print pad. The paper describes the extent of deformation of the testing object just depending on the heating of printing pad. The authors also suggest a compromise between excessive deformation of underlying layers and therefore adequate changing the physical size of the product and low adhesion of the product to the underlying heating plate, which can cause tearing of the product during the printing process.

Název v anglickém jazyce

Deformation of print PLA material depending on the temperature of reheating printing pad

Popis výsledku anglicky

This article presents results of partial research aimed at the prototyping - 3D printing. The authors focus on material polylactic acid (PLA) which is widely used for the manufacture of components using 3D printing. Technology of gradual laying of plastic layers causes tension and subsequently deformation of a printed components. This can lead to the tearing of the product from the print pad. The paper describes the extent of deformation of the testing object just depending on the heating of printing pad. The authors also suggest a compromise between excessive deformation of underlying layers and therefore adequate changing the physical size of the product and low adhesion of the product to the underlying heating plate, which can cause tearing of the product during the printing process.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

136-140

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—