Turning of Overlays Using Kennametal Hertel Tools

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F03%3A00005006" target="_blank" >RIV/60460709:41310/03:00005006 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Turning of Overlays Using Kennametal Hertel Tools

Popis výsledku v původním jazyce

Turning of overlays has in comparison with turning of drawn or rolled semi-products some differences, which follow from specific properties of overlays. Therefore it is not possible to use published standards for optimization of cutting conditions. In practice optimum cutting conditions are usually determined from long-term tool-life test results. These time-consuming tests must be done for each combination of overlay - cutting materials. On the basis of evaluated tests made in our department there wasdetermined tool-life T - cutting speed vc relationship for turning of overlay made using wire C 508 for pulsed carbon dioxide shielded surfacing. Afterwards there was elaborated optimization of cutting conditions at minimum machining costs criterion forrelatively wide scale of workshop economic indexes. In the paper there are published results of tests, made with tool material KC 9315 of firm Kennametal Hertel. On the basis of test results it is possible to state, that application of th

Název v anglickém jazyce

Turning of Overlays Using Kennametal Hertel Tools

Popis výsledku anglicky

Turning of overlays has in comparison with turning of drawn or rolled semi-products some differences, which follow from specific properties of overlays. Therefore it is not possible to use published standards for optimization of cutting conditions. In practice optimum cutting conditions are usually determined from long-term tool-life test results. These time-consuming tests must be done for each combination of overlay - cutting materials. On the basis of evaluated tests made in our department there wasdetermined tool-life T - cutting speed vc relationship for turning of overlay made using wire C 508 for pulsed carbon dioxide shielded surfacing. Afterwards there was elaborated optimization of cutting conditions at minimum machining costs criterion forrelatively wide scale of workshop economic indexes. In the paper there are published results of tests, made with tool material KC 9315 of firm Kennametal Hertel. On the basis of test results it is possible to state, that application of th

Druh

D - Stať ve sborníku

CEP obor

JQ - Strojní zařízení a nástroje

OECD FORD obor

—

Projekt

—

Návaznosti

Z - Vyzkumny zamer (s odkazem do CEZ)

Rok uplatnění

2003

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název statě ve sborníku

17th International Conference on Production Research

ISBN

0-9721257-3-6

ISSN

—

e-ISSN

—

Počet stran výsledku

6

Strana od-do

1-6

Název nakladatele

Virginia Tech

Místo vydání

Blackburg, Virginia, USA

Místo konání akce

Blackburg, Virginia, USA

Datum konání akce

3. 8. 2003

Typ akce podle státní příslušnosti

WRD - Celosvětová akce

Kód UT WoS článku

—