DIMENSIONING OF THE BONDED LAP JOINT

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F10%3A19431" target="_blank" >RIV/60460709:41310/10:19431 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

DIMENSIONING OF THE BONDED LAP JOINT

Popis výsledku v původním jazyce

Bonded joint is a complex assembly, which creation and following use is limited by a row of factors. The primary factors are the properties of the bonded material and of the adhesive. The stress distribution in the bonded joint is substantially influenced by the bonded joint geometry and by the deformation characteristics. Laboratory experiments are intent on the above mentioned influences for bonded lap joints, which are very used in practice. The bonded joints geometrical parameters are substantial for the constructional parameters and for costs determination. At the lower lapping length the failure of the bonded joint occurs and the maximum loading capacity of the bonded material is not fully utilized. On the contrary using the lapping length over its optimum value the failure of the bonded material occurs. At the same time the total weight of the bonded assembly increases. Therefore it is important to determine the bonded joint optimum values which secure the reliability and which

Název v anglickém jazyce

DIMENSIONING OF THE BONDED LAP JOINT

Popis výsledku anglicky

Bonded joint is a complex assembly, which creation and following use is limited by a row of factors. The primary factors are the properties of the bonded material and of the adhesive. The stress distribution in the bonded joint is substantially influenced by the bonded joint geometry and by the deformation characteristics. Laboratory experiments are intent on the above mentioned influences for bonded lap joints, which are very used in practice. The bonded joints geometrical parameters are substantial for the constructional parameters and for costs determination. At the lower lapping length the failure of the bonded joint occurs and the maximum loading capacity of the bonded material is not fully utilized. On the contrary using the lapping length over its optimum value the failure of the bonded material occurs. At the same time the total weight of the bonded assembly increases. Therefore it is important to determine the bonded joint optimum values which secure the reliability and which

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2010

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Research in Agricultural Engineering (Zemědělská technika)

ISSN

1212-9151

e-ISSN

—

Svazek periodika

56

Číslo periodika v rámci svazku

2

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

10

Strana od-do

—

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—