Influence of cutting fluid on abrasive-free ultrasonic finishing of aluminium alloy

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F15%3A68993" target="_blank" >RIV/60460709:41310/15:68993 - isvavai.cz</a>

Nalezeny alternativní kódy

RIV/44555601:13420/15:43886953

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of cutting fluid on abrasive-free ultrasonic finishing of aluminium alloy

Popis výsledku v původním jazyce

The aim of the research was to compare a classical (turning) machining and an abrasive-free ultrasonic machining (bufo) at aluminium alloy. An ultrasonic set I - 4 consisted of the ultrasonic generator, power output 630 W and working frequency 22 kHz ? 10%, was used for the research. Three different cutting fluids containing nanoparticles were compared at the abrasive-free ultrasonic finishing. A rise of a hardness HV0.05 and HBW2.5/62.5 compared to the classical machining occurred at the application ofthe abrasive-free ultrasonic machining technology at the aluminium alloy by various cutting fluids containing nanoparticles. It is obvious from the results that a considerable fall of the surface roughness parameters Ra and Rz occurred at the application using the abrasivefree ultrasonic finishing.

Název v anglickém jazyce

Influence of cutting fluid on abrasive-free ultrasonic finishing of aluminium alloy

Popis výsledku anglicky

The aim of the research was to compare a classical (turning) machining and an abrasive-free ultrasonic machining (bufo) at aluminium alloy. An ultrasonic set I - 4 consisted of the ultrasonic generator, power output 630 W and working frequency 22 kHz ? 10%, was used for the research. Three different cutting fluids containing nanoparticles were compared at the abrasive-free ultrasonic finishing. A rise of a hardness HV0.05 and HBW2.5/62.5 compared to the classical machining occurred at the application ofthe abrasive-free ultrasonic machining technology at the aluminium alloy by various cutting fluids containing nanoparticles. It is obvious from the results that a considerable fall of the surface roughness parameters Ra and Rz occurred at the application using the abrasivefree ultrasonic finishing.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JR - Ostatní strojírenství

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2015

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

15

Číslo periodika v rámci svazku

4

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

5

Strana od-do

710-714

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—