Influence of the degreaser type on the bonded joint strength

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F16%3A72160" target="_blank" >RIV/60460709:41310/16:72160 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Influence of the degreaser type on the bonded joint strength

Popis výsledku v původním jazyce

In the report the results of bonded joints laboratory tests are published. The determination of the tensile lap-shear strength of rigid-to-rigid bonded assemblies according to the standard CSN EN 1465 (66 8510) was the aim of the carried out tests. The samples were made from steel sheets. For bonding of test samples four different types of adhesives were used (two super glue adhesives, one epoxy adhesive and one contact adhesive). Ahead of bonding the surfaces of all samples were blasted using corundum grit and degreased. For degreasing four various types of five different degreasers were used, namely perchlorethylene, acetone, methanol, technical gasoline and toluene. Then the samples were dried using warm air. For comparison the blasted samples without degreasing were bonded, too. At the tested samples bonding the consumption of adhesive was determined. From the adhesive consumption for one bonded joint and from the adhesive price the costs of one sample bonding were calculated. After curing the bo

Název v anglickém jazyce

Influence of the degreaser type on the bonded joint strength

Popis výsledku anglicky

In the report the results of bonded joints laboratory tests are published. The determination of the tensile lap-shear strength of rigid-to-rigid bonded assemblies according to the standard CSN EN 1465 (66 8510) was the aim of the carried out tests. The samples were made from steel sheets. For bonding of test samples four different types of adhesives were used (two super glue adhesives, one epoxy adhesive and one contact adhesive). Ahead of bonding the surfaces of all samples were blasted using corundum grit and degreased. For degreasing four various types of five different degreasers were used, namely perchlorethylene, acetone, methanol, technical gasoline and toluene. Then the samples were dried using warm air. For comparison the blasted samples without degreasing were bonded, too. At the tested samples bonding the consumption of adhesive was determined. From the adhesive consumption for one bonded joint and from the adhesive price the costs of one sample bonding were calculated. After curing the bo

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JS - Řízení spolehlivosti a kvality, zkušebnictví

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2016

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Manufacturing Technology

ISSN

1213-2489

e-ISSN

—

Svazek periodika

16

Číslo periodika v rámci svazku

6

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

7

Strana od-do

1248-1254

Kód UT WoS článku

—

EID výsledku v databázi Scopus

2-s2.0-85007416135