Determination of conversion relations for the use of small hydrodynamic pumps in reverse turbine operation
Identifikátory výsledku
Kód výsledku v IS VaVaI
<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41310%2F18%3A76455" target="_blank" >RIV/60460709:41310/18:76455 - isvavai.cz</a>
Výsledek na webu
<a href="http://dx.doi.org/10.15159/AR.18.032" target="_blank" >http://dx.doi.org/10.15159/AR.18.032</a>
DOI - Digital Object Identifier
<a href="http://dx.doi.org/10.15159/AR.18.032" target="_blank" >10.15159/AR.18.032</a>
Alternativní jazyky
Jazyk výsledku
angličtina
Název v původním jazyce
Determination of conversion relations for the use of small hydrodynamic pumps in reverse turbine operation
Popis výsledku v původním jazyce
In small-scale hydropower, hydrodynamic pumps used in reverse mode are an important economical alternative to conventional water turbines. Efficient utilisation of these devices however requires taking into account all the specifics of the reverse pump operation and optimise the pump design for maximum utilisation of the hydro-technical potential of the deployment site. The article compares existing conversion models, describes initial theoretical assumptions and determines new conversion relations for the design of pumps as turbines (PAT) for the lowest power and specific speed category. The validity of the conversion relations is experimentally verified on a hydraulic test circuit with a radial centrifugal pump tested in both pump and turbine operation modes. The results of the verification of the new conversion relations proved better correspondence to reality within this category of machines than that reported by the previously used conversion models.
Název v anglickém jazyce
Determination of conversion relations for the use of small hydrodynamic pumps in reverse turbine operation
Popis výsledku anglicky
In small-scale hydropower, hydrodynamic pumps used in reverse mode are an important economical alternative to conventional water turbines. Efficient utilisation of these devices however requires taking into account all the specifics of the reverse pump operation and optimise the pump design for maximum utilisation of the hydro-technical potential of the deployment site. The article compares existing conversion models, describes initial theoretical assumptions and determines new conversion relations for the design of pumps as turbines (PAT) for the lowest power and specific speed category. The validity of the conversion relations is experimentally verified on a hydraulic test circuit with a radial centrifugal pump tested in both pump and turbine operation modes. The results of the verification of the new conversion relations proved better correspondence to reality within this category of machines than that reported by the previously used conversion models.
Klasifikace
Druh
J<sub>SC</sub> - Článek v periodiku v databázi SCOPUS
CEP obor
—
OECD FORD obor
20704 - Energy and fuels
Návaznosti výsledku
Projekt
—
Návaznosti
S - Specificky vyzkum na vysokych skolach
Ostatní
Rok uplatnění
2018
Kód důvěrnosti údajů
S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů
Údaje specifické pro druh výsledku
Název periodika
Agronomy Research
ISSN
1406-894X
e-ISSN
—
Svazek periodika
16
Číslo periodika v rámci svazku
Special Issue 1
Stát vydavatele periodika
CZ - Česká republika
Počet stran výsledku
9
Strana od-do
1200-1208
Kód UT WoS článku
—
EID výsledku v databázi Scopus
2-s2.0-85051132632