Optimization of the cutting process of wood-based agglomerated materials by abrasive water-jet

Kód výsledku v IS VaVaI

<a href="https://www.isvavai.cz/riv?ss=detail&h=RIV%2F60460709%3A41320%2F14%3A64457" target="_blank" >RIV/60460709:41320/14:64457 - isvavai.cz</a>

Výsledek na webu

—

DOI - Digital Object Identifier

—

Jazyk výsledku

angličtina

Název v původním jazyce

Optimization of the cutting process of wood-based agglomerated materials by abrasive water-jet

Popis výsledku v původním jazyce

This paper deals with the cutting MDF, OSB, and plywood boards by abrasive water-jet (GMA Garnet Australian, grain size 80, MESH = 0.188 mm), with a kerf width depending on the material properties and technical parameters (material thickness, cutting direction, abrasive flow, and feed speed). The entry of water-jet cutting in the longitudinal direction produces changes in the material due to lateral leads spreading the width of the cut joints by an average of 0.20 mm for MDF boards, 0.3 mm for OSB boards, and 0.17 mm for plywood. On the exit side of the material, the water has the opposite effect. In relation to the thicknesses of the material, the width of the cut joints increases. The experiment has shown that the optimum value of the feed speed is explicitly 400 mm.min-1, at which the kerf width reaches the lowest dimensions both at entry and exit, and the abrasive flow of 450 g.min-1 has been shown as optimum.

Název v anglickém jazyce

Optimization of the cutting process of wood-based agglomerated materials by abrasive water-jet

Popis výsledku anglicky

This paper deals with the cutting MDF, OSB, and plywood boards by abrasive water-jet (GMA Garnet Australian, grain size 80, MESH = 0.188 mm), with a kerf width depending on the material properties and technical parameters (material thickness, cutting direction, abrasive flow, and feed speed). The entry of water-jet cutting in the longitudinal direction produces changes in the material due to lateral leads spreading the width of the cut joints by an average of 0.20 mm for MDF boards, 0.3 mm for OSB boards, and 0.17 mm for plywood. On the exit side of the material, the water has the opposite effect. In relation to the thicknesses of the material, the width of the cut joints increases. The experiment has shown that the optimum value of the feed speed is explicitly 400 mm.min-1, at which the kerf width reaches the lowest dimensions both at entry and exit, and the abrasive flow of 450 g.min-1 has been shown as optimum.

Druh

J_x - Nezařazeno - Článek v odborném periodiku (Jimp, Jsc a Jost)

CEP obor

JP - Průmyslové procesy a zpracování

OECD FORD obor

—

Projekt

—

Návaznosti

S - Specificky vyzkum na vysokych skolach

Rok uplatnění

2014

Kód důvěrnosti údajů

S - Úplné a pravdivé údaje o projektu nepodléhají ochraně podle zvláštních právních předpisů

Název periodika

Acta Silvatica et Lignaria Hungarica

ISSN

1786-691X

e-ISSN

—

Svazek periodika

10

Číslo periodika v rámci svazku

1

Stát vydavatele periodika

CZ - Česká republika

Počet stran výsledku

17

Strana od-do

31-47

Kód UT WoS článku

—

EID výsledku v databázi Scopus

—